Hello Wolfgang, Jean-Christophe,
Wolfgang Denk wrote:
> Dear Daniel,
>
> In message <20090904211358.gr30...@game.jcrosoft.org> Jean-Christophe wrote:
>>> +#ifdef CONFIG_REVISION_TAG
>>> +u32 get_board_rev(void)
>>> +{
>>> + return hw_rev | 0x100;
>>> +}
>>> +#endif
>>> +
>>> +int misc_init_r(void)
>>> +{
>>> +#ifdef CONFIG_MACB
>>> + u32 hwaddr_btm;
>>> + u16 hwaddr_top;
>>> + u8 mac[6];
>>> +
>>> + /* Set ethernet address */
>>> + if (!eth_getenv_enetaddr("ethaddr", mac)) {
>>> + puts("Missing environment variable 'ethaddr'\n");
>>> + } else {
>>> + hwaddr_btm = mac[0] | mac[1] << 8 | mac[2] << 16 | mac[3] << 24;
>>> + hwaddr_top = mac[4] | mac[5] << 8;
>>> + writel(hwaddr_btm, (void *)(AT91SAM9263_BASE_EMAC + MACB_SA1B));
>>> + writel(hwaddr_top, (void *)(AT91SAM9263_BASE_EMAC + MACB_SA1T));
>> nack this will be done when u-boot will need to use the macb#
Just imagine: U-boot boots a Linux kernel from NAND flash. It does NOT need the
ethernet interface, so it does NOT initialize ethernet, so the ethernet address
will NOT be written to the EMAC module!
As a result, Linux will assign a random address, that is not acceptable!
>
> Jean-Christophe means: The Etherent interface must not be always
> initialized, but only when it is needed and used within U-Boot itself,
> i. e. if U-boot is performing anetwork command. See also item 2 at
> http://www.denx.de/wiki/U-Boot/DesignPrinciples and
> http://www.denx.de/wiki/view/DULG/EthernetDoesNotWorkInLinux
>
> Best regards,
>
> Wolfgang Denk
>
I know about it.
But this patch does NOT initialize the Ethernet Interface. It JUST write
the ethernet address to the EMAC module!
So please ACK this patch.
Regards,
Daniel Gorsulowski
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
