Hi Andreas, 2016-05-19 20:16 GMT+02:00 Andreas Dannenberg <dannenb...@ti.com>:
> Hi Michal, > > On Thu, May 19, 2016 at 06:38:04PM +0200, Michal Simek wrote: > > On 19.5.2016 18:15, Andreas Dannenberg wrote: > > > On Tue, May 17, 2016 at 07:00:24PM +0200, Michal Simek wrote: > > >> Support loading FIT in SPL for RAM bootmode. > > >> CONFIG_SPL_LOAD_FIT_ADRESS points to address where FIT image is stored > > >> in memory. > > >> > > >> Signed-off-by: Michal Simek <michal.si...@xilinx.com> > > >> Reviewed-by: Simon Glass <s...@chromium.org> > > >> --- > > > > > > Reviewed-by: Andreas Dannenberg <dannenb...@ti.com> > > > > > > > > > That's a very useful addition to the SPL FIT toolbox! I have a use case > > > where I may need to decrypt/authenticate an SPL FIT image in its > entirety > > > before processing it so this can be used for this as well. > > > > Do you have also use case where you need to load more files from FIT? > > There is loadable entry in FIT config entry. > > Not yet but I may get there. I'm experimenting with using U-Boot to load > and install a secure monitor mode application (specifically, OP-TEE OS), > so that will need to come from somewhere eventually and FIT would be a > natural place for that binary to reside since we can easily authenticate > it. ok what arch? What's the flow which you want to support? SPL to load OPTEE and ATF and full u-boot and jump to ATF which runs OPTEE and run to U-Boot? Thanks, Michal _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
