On 15:12 Fri 04 Sep , Tom Rix wrote: > The preferred serial output comes from the debug board. > When the debug board is disconnected, fall back on using > usbtty from the usb connector on the Zoom2 board. > > This shows up as /dev/ttyACM0 in a linux host. > > Signed-off-by: Tom Rix <tom....@windriver.com> > --- > board/omap3/zoom2/zoom2_serial.c | 16 ++++++++++++++++ > include/configs/omap3_zoom2.h | 17 +++++++++++++++++ > 2 files changed, 33 insertions(+), 0 deletions(-) > > diff --git a/board/omap3/zoom2/zoom2_serial.c > b/board/omap3/zoom2/zoom2_serial.c > index a3d777d..434696a 100644 > --- a/board/omap3/zoom2/zoom2_serial.c > +++ b/board/omap3/zoom2/zoom2_serial.c > @@ -87,6 +87,10 @@ void quad_putc_dev (unsigned long base, const char c) > > NS16550_putc ((NS16550_t) base, c); > } > +#ifdef CONFIG_USB_TTY why not do this #ifndef CONFIG_USB_TTY #define usbtty_putc(c) #define usbtty_puts(s) #define usbtty_getc() 0 #define usbtty_tstc() 0 #endif
and then avoid the ifdef Best Regards, J. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
