On 03/24/2016 03:40 AM, Stefan Roese wrote: > On 02.02.2016 00:35, Chris Packham wrote: >> Claim the MPP pins for the NAND flash controller only when it's actually >> being used. This allows the pins to be shared with the SPI interface >> which already supports an equivalent on-access MPP reconfiguration. >> >> Reviewed-by: Mark Tomlinson <mark.tomlin...@alliedtelesis.co.nz> >> Signed-off-by: Chris Packham <judge.pack...@gmail.com> >> --- >> I haven't wrapped this with a configuration option because I think it >> should be safe to enable by default. It will either re-apply the same >> MPP configuration that has already been done in the board init or put >> the MPP pins into the correct mode to access NAND. >> >> I've only got access to one kirkwood based board with NAND flash so I'd >> appreciate some feedback from someone with access to a few different >> boards. >> >> From the datasheets I have access to it looks like there is only one >> possible MPP configuration for NF_IO[0-7] so that is what I've >> implemented. I'm not aware of anything using this driver that needs a >> different MPP config. >> >> Changes in v2: >> - make nand_config static const > > Scott, are you okay with this patch in v2?
Yes. Acked-by: Scott Wood <o...@buserror.net> > If yes, will you pull it? > Or should I include it in a marvell pull request? Go ahead. -Scott _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
