As per mmc device tree binding documentation card detect gpio has
to be active low signal. When a hardware is designed with active
high card detect, gpio polarity has to be changed with
cd-inverted dt property.
In DRA72x and AM57xx EVMs the card detect gpio is designed as
active low gpio. So correcting the dt card detect gpio
definition.
Also adding card-detect gpio for DRA74x EVM.
Signed-off-by: Mugunthan V N <mugunthan...@ti.com>
---
arch/arm/dts/am57xx-beagle-x15.dts | 2 +-
arch/arm/dts/dra7-evm.dts | 5 +++++
arch/arm/dts/dra72-evm.dts | 2 +-
3 files changed, 7 insertions(+), 2 deletions(-)
diff --git a/arch/arm/dts/am57xx-beagle-x15.dts
b/arch/arm/dts/am57xx-beagle-x15.dts
index e424562..38b266a 100644
--- a/arch/arm/dts/am57xx-beagle-x15.dts
+++ b/arch/arm/dts/am57xx-beagle-x15.dts
@@ -586,7 +586,7 @@
vmmc_aux-supply = <&vdd_3v3>;
pbias-supply = <&pbias_mmc_reg>;
bus-width = <4>;
- cd-gpios = <&gpio6 27 0>; /* gpio 219 */
+ cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>; /* gpio 219 */
};
&mmc2 {
diff --git a/arch/arm/dts/dra7-evm.dts b/arch/arm/dts/dra7-evm.dts
index 242fd53..08ef04e 100644
--- a/arch/arm/dts/dra7-evm.dts
+++ b/arch/arm/dts/dra7-evm.dts
@@ -469,6 +469,11 @@
status = "okay";
vmmc-supply = <&ldo1_reg>;
bus-width = <4>;
+ /*
+ * SDCD signal is not being used here - using the fact that GPIO mode
+ * is always hardwired.
+ */
+ cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>;
};
&mmc2 {
diff --git a/arch/arm/dts/dra72-evm.dts b/arch/arm/dts/dra72-evm.dts
index fc2d167..205103e 100644
--- a/arch/arm/dts/dra72-evm.dts
+++ b/arch/arm/dts/dra72-evm.dts
@@ -503,7 +503,7 @@
* SDCD signal is not being used here - using the fact that GPIO mode
* is a viable alternative
*/
- cd-gpios = <&gpio6 27 0>;
+ cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>;
};
&mmc2 {
--
2.8.0.rc3.9.g44915db
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
