Hi Michal, On 18 February 2016 at 09:01, Michal Simek <michal.si...@xilinx.com> wrote: > Compile DCC serial driver by default. > > Signed-off-by: Michal Simek <michal.si...@xilinx.com> > --- > > include/configs/xilinx_zynqmp.h | 9 +++------ > include/configs/zynq-common.h | 8 ++------ > 2 files changed, 5 insertions(+), 12 deletions(-) > > diff --git a/include/configs/xilinx_zynqmp.h b/include/configs/xilinx_zynqmp.h > index 28622dec1882..8a9ad03cb102 100644 > --- a/include/configs/xilinx_zynqmp.h > +++ b/include/configs/xilinx_zynqmp.h > @@ -53,12 +53,9 @@ > #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 0x2000000) > > /* Serial setup */ > -#if defined(CONFIG_ZYNQMP_DCC) > -# define CONFIG_ARM_DCC > -# define CONFIG_CPU_ARMV8 > -#else > -# define CONFIG_ZYNQ_SERIAL > -#endif > +#define CONFIG_ARM_DCC > +#define CONFIG_CPU_ARMV8 > +#define CONFIG_ZYNQ_SERIAL
Can some of these go in either the board _defconfig files or as a 'default y' in Zynq's Kconfig? > > #define CONFIG_CONS_INDEX 0 > #define CONFIG_BAUDRATE 115200 > diff --git a/include/configs/zynq-common.h b/include/configs/zynq-common.h > index e8c3ef0c3872..ec4884878165 100644 > --- a/include/configs/zynq-common.h > +++ b/include/configs/zynq-common.h > @@ -36,12 +36,8 @@ > #define CONFIG_SYS_BAUDRATE_TABLE \ > {300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, > 230400} > > -/* DCC driver */ > -#if defined(CONFIG_ZYNQ_DCC) > -# define CONFIG_ARM_DCC > -#else > -# define CONFIG_ZYNQ_SERIAL > -#endif > +#define CONFIG_ARM_DCC > +#define CONFIG_ZYNQ_SERIAL > > #define CONFIG_ZYNQ_GPIO > > -- > 1.9.1 > Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot