Dear alfred steele,
In message <528f13590908200918s6f1a00d4v294867f350037...@mail.gmail.com> you
wrote:
>
> What is the general boot sequence for u-boot. IIRC, its the cpu
> specific start followed by board specfic stuff, then general init
> stuff (like misc_init_f) and then the common stuff.
Not really. First low level intialization gets done, needed to set up
a reasonable C execution environment; then all initialization running
from flash gets done, RAM initalization included; then U-Boot
relocates to RAM and initializes flash end the rest of the system.
There are CPU resp. board specific and common parts in all of these
steps, or at least there may be.
> The reason i am asking this i want to inject my own boot path based on
> the presence of certain boot peripherals. I want to override the
> "boot_args" with my custom-defined bootargs and then execute "bootm"
> from a predefined RAM address.
No need to change any code then. Just define the needed environment
variables to contain the commands you want.
> I want to know which is the most appropriate place for soing this. I
> was initilally thinking it would end up in the board specific
> code(board/<boardname>.c) but i am a bit confused when i read the
> main/common code.
Don't change any code. Use the scripting capabilities of U-Boot's
environment variables.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
Time is a drug. Too much of it kills you.
- Terry Pratchett, _Small Gods_
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
