Set free_count to zero before walking through ai->erase list
in wl_init().
As U-Boot has no workqueue/threads, it immediately calls
erase_worker(), which increase for each erased block
free_count. Without this patch, free_count gets after
this initialized to zero in wl_init(), so the free_count
variable always has the maybe wrong value 0.
Detected this behaviour on the dxr2 board, where the
UBI fastmap gets not written when attaching/dettaching
on an empty NAND. It drops instead the error message:
could not find any anchor PEB
With this patch, fastmap gets written on dettach.
Signed-off-by: Heiko Schocher <h...@denx.de>
---
added Richard to this EMail, as maybe this could be a problem
in linux too ... ?
drivers/mtd/ubi/wl.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/mtd/ubi/wl.c b/drivers/mtd/ubi/wl.c
index 507b091..e823ca5 100644
--- a/drivers/mtd/ubi/wl.c
+++ b/drivers/mtd/ubi/wl.c
@@ -1528,6 +1528,7 @@ int ubi_wl_init(struct ubi_device *ubi, struct
ubi_attach_info *ai)
INIT_LIST_HEAD(&ubi->pq[i]);
ubi->pq_head = 0;
+ ubi->free_count = 0;
list_for_each_entry_safe(aeb, tmp, &ai->erase, u.list) {
cond_resched();
@@ -1546,7 +1547,6 @@ int ubi_wl_init(struct ubi_device *ubi, struct
ubi_attach_info *ai)
found_pebs++;
}
- ubi->free_count = 0;
list_for_each_entry(aeb, &ai->free, u.list) {
cond_resched();
--
2.5.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
