On Monday 17 August 2009 19:37:53 you wrote: > > -----Original Message----- > > From: u-boot-boun...@lists.denx.de > > [mailto:u-boot-boun...@lists.denx.de] On Behalf Of Tuma > > Sent: Monday, August 17, 2009 7:26 PM > > To: Wolfgang Denk; U-Boot Mailing List > > Subject: Re: [U-Boot] BMP display. > > > > On Monday 17 August 2009 16:38:31 you wrote: > > > Dear Tuma, > > > > > > again: please keep the mailing list on Cc: !!! > > > > > > In message <200908171631.17975.chernigovs...@spb.gs.ru> you wrote: > > > > Okay. Is new version configurable for OMAP3evm out of the box? > > > > > > Yes. > > > > > > > And is the v2009.08-rc2 stable enought? > > > > > > Yes. > > > > Thank you. I've downloaded new U-Boot 2009.08.rc2. > > I have some error while making it. > > I do: > > make distclean (Okay) > > make omap3_evm_config (Okay) > > make > > > > And get: > > > > make[1]: arm-linux-gcc: Command not found > > > > My old U-Boot used "arm-none-linux-gnueabi-gcc" which make > > system could easyly > > find on my system. > > Should I install some new software to build new U-Boot? > > Or configure existing Makefile? > > Can you try: > make CROSS_COMPILE=arm-none-linux-gnueabi-
Oo, thank you! I forgot about CROSS_COMPILE=. In my old U-Boot this parameter was set in Makefile. In 2009 CROSS_COMPILE= in Makefile was ignored. U-boot 2009 is built now, and runs on OMAP3 evm. So I have to put i2c driver files (as .h as .c) to drivers/i2c and LCD driver file s (as .h as .c) to drivers/video? > > > Best regards, > > > > > > Wolfgang Denk > > > > -- > > Software Developer > > General Satellite Corp. > > _______________________________________________ > > U-Boot mailing list > > U-Boot@lists.denx.de > > http://lists.denx.de/mailman/listinfo/u-boot -- Software Developer General Satellite Corp. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
