On Friday, December 11, 2015 at 04:46:40 PM, Michal Simek wrote: > On 11.12.2015 16:07, Marek Vasut wrote: > > On Friday, December 11, 2015 at 03:48:09 PM, Nathan Rossi wrote: > >> The Device Model sequence alias feature is required by some Uclasses. > >> Instead of disabling the feature for all SPL targets allow it to be > >> configured. > >> > >> The config option is disabled by default to reduce code size for targets > >> that are not interested or do not require this feature. > >> > >> Signed-off-by: Nathan Rossi <nat...@nathanrossi.com> > >> Cc: Simon Glass <s...@chromium.org> > >> Cc: Masahiro Yamada <yamada.masah...@socionext.com> > >> Cc: Linus Walleij <linus.wall...@linaro.org> > >> Cc: Marek Vasut <ma...@denx.de> > >> Cc: Michal Simek <michal.si...@xilinx.com> > >> --- > >> Based on a small amount of inspection for the Zynq platform, enabling > >> this config option adds ~1KB of code size. > >> > >> Also on a side note, this might affect the socfpga target as it forcibly > >> overrides the #undef from config_uncmd_spl.h in its common header. I > >> have Cc'd the respective maintainer for this reason. > > > > The fix for SoCFPGA is easy -- enable the SPL_DM_SEQ_ALIAS in > > configs/socfpga*. It is needed for booting from QSPI NOR. > > That's probably not the best solution. But of course we can use it. > IRC Stefan had the same problem.
So what is the solution ? Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
