[U-Boot] [PATCH v3 06/14] net: gem: Remove phydev variable

[Michal Simek]

Resort code to use priv->phydev variable directly.
It will simplify move to DM.

Signed-off-by: Michal Simek <michal.si...@xilinx.com>
---

Changes in v3: None
Changes in v2: None

 drivers/net/zynq_gem.c | 23 ++++++++++-------------
 1 file changed, 10 insertions(+), 13 deletions(-)

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 65ea5deb23c6..8f3fe9130066 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -315,7 +315,6 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis)
        u32 i;
        int ret;
        unsigned long clk_rate = 0;
-       struct phy_device *phydev;
        struct zynq_gem_regs *regs = (struct zynq_gem_regs *)dev->iobase;
        struct zynq_gem_priv *priv = dev->priv;
        struct emac_bd *dummy_tx_bd = &priv->tx_bd[TX_FREE_DESC];
@@ -394,23 +393,21 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * 
bis)
                return ret;
        }
 
-       /* interface - look at tsec */
-       phydev = phy_connect(priv->bus, priv->phyaddr, dev,
-                            priv->interface);
+       priv->phydev = phy_connect(priv->bus, priv->phyaddr, dev,
+                                  priv->interface);
 
-       phydev->supported = supported | ADVERTISED_Pause |
-                           ADVERTISED_Asym_Pause;
-       phydev->advertising = phydev->supported;
-       priv->phydev = phydev;
-       phy_config(phydev);
-       phy_startup(phydev);
+       priv->phydev->supported = supported | ADVERTISED_Pause |
+                                 ADVERTISED_Asym_Pause;
+       priv->phydev->advertising = priv->phydev->supported;
+       phy_config(priv->phydev);
+       phy_startup(priv->phydev);
 
-       if (!phydev->link) {
-               printf("%s: No link.\n", phydev->dev->name);
+       if (!priv->phydev->link) {
+               printf("%s: No link.\n", priv->phydev->dev->name);
                return -1;
        }
 
-       switch (phydev->speed) {
+       switch (priv->phydev->speed) {
        case SPEED_1000:
                writel(ZYNQ_GEM_NWCFG_INIT | ZYNQ_GEM_NWCFG_SPEED1000,
                       &regs->nwcfg);
-- 
1.9.1

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot