On 15/11/2015 22:47, Michael Heimpold wrote:
> At the moment, the desired brownout is at 1.0V. However,
> this setting cannot be realized by hardware since we have
> only 3 bits to represent the voltage difference from the
> target value.
> 
> Target value is 1500 mV, brownout target is 1000 mV,
> voltage steps are 25 mV.
> 
> Register content calculation:
>   (1500 [mV] - 1000 [mV]) / 25 [mV] = 20 (decimal) = 0x14
> 
>   Register takes only 3 bits, that is 0x4.
> 
> But 0x4 * 25 [mV] = 100 [mV], that means that actual
> brownout level is 1500 [mV] - 100 [mV] = 1.4 V.
> 
> Minimum possible BO level is
>   1500 [mV] - 0x7 * 25 [mV] = 1315 [mV].
> 
> So lets use this value as desired BO value (which is
> also the same as FSL bootlets use).
> 
> Signed-off-by: Michael Heimpold <m...@heimpold.de>
> Cc: Marek Vasut <ma...@denx.de>
> Cc: Otavio Salvador <ota...@ossystems.com.br>
> Cc: Fabio Estevam <fabio.este...@freescale.com>
> ---

Applied to u-boot-imx, thanks!

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to