Roy, Do you remember the reason why we use different virtual memory address from pci bus address with 36-bit? For example
include/configs/P1022DS.h-496-#define CONFIG_SYS_PCIE1_MEM_VIRT 0xc0000000 include/configs/P1022DS.h-497-#ifdef CONFIG_PHYS_64BIT include/configs/P1022DS.h:498:#define CONFIG_SYS_PCIE1_MEM_BUS 0xe0000000 include/configs/P1022DS.h-499-#define CONFIG_SYS_PCIE1_MEM_PHYS 0xc40000000ull include/configs/P1022DS.h-500-#else include/configs/P1022DS.h:501:#define CONFIG_SYS_PCIE1_MEM_BUS 0xc0000000 include/configs/P1022DS.h-502-#define CONFIG_SYS_PCIE1_MEM_PHYS 0xc0000000 include/configs/P1022DS.h-503-#endif As far as I can tell, the following is the mapping TLB: MEM_VIRT=>MEM_PHYS PCI: MEM_BUS=>MEM_PHYS LAW: MEM_PHYS=>pcie interface Being different for MEM_VIRT and MEM_BUS cause confusion. When I run "pci header" command to show the BARs, I expect I can use "md" to access the BAR address. That's not the case if MEM_BUS is different from MEM_VIRT. I forget why we did this for 36-bit addressing. The MEM_VIRT is the same as MEM_BUS for 32-bit addressing. And why do we use the same MEM_BUS address for all PCIe hose? I know they are not conflicting, but is it necessary? Let me know if you have any concerns. Otherwise I will change all platforms to use consistent addresses. York _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
