This is necessary to make sure that all the pins used for SPI access, especially the CS, are configured back to the NAND Flash interface. Otherwise, if either newenv or update are called, u-boot cannot access the NAND Flash anymore.
Signed-off-by: Valentin Longchamp <valentin.longch...@keymile.com> --- Changes in v3: None Changes in v2: None include/configs/km/km_arm.h | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) diff --git a/include/configs/km/km_arm.h b/include/configs/km/km_arm.h index 15fca1a..7a0d3b1 100644 --- a/include/configs/km/km_arm.h +++ b/include/configs/km/km_arm.h @@ -271,13 +271,15 @@ int get_scl(void); #define CONFIG_KM_UPDATE_UBOOT \ "update=" \ "sf probe 0;sf erase 0 +${filesize};" \ - "sf write ${load_addr_r} 0 ${filesize};\0" + "sf write ${load_addr_r} 0 ${filesize};" \ + "sf release\0" #if defined CONFIG_KM_ENV_IS_IN_SPI_NOR #define CONFIG_KM_NEW_ENV \ "newenv=sf probe 0;" \ "sf erase " __stringify(CONFIG_ENV_OFFSET) " " \ - __stringify(CONFIG_ENV_TOTAL_SIZE)"\0" + __stringify(CONFIG_ENV_TOTAL_SIZE)";" \ + "sf release\0" #else #define CONFIG_KM_NEW_ENV \ "newenv=setenv addr 0x100000 && " \ -- 1.8.3.1 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot