On Fri, Nov 06, 2015 at 07:22:00PM -0200, Fabio Estevam wrote:
> On Fri, Nov 6, 2015 at 6:22 PM, Michael Welling <mwell...@ieee.org> wrote:
> > Lets try this again with list membership.
> >
> > I have run into an issue with a KSZ9031 Gigabit Ethernet PHY on an IMX6
> > module.
> >
> > After booting into Linux and rebooting the ethernet fails consistently.
> >
> > With a bit of investigation I found that the power-down bit in the PHY
> > control
> > register is being set on reboot.
> >
> > => dhcp
> > BOOTP broadcast 1
> > BOOTP broadcast 2
> > BOOTP broadcast 3
> > BOOTP broadcast 4
> > BOOTP broadcast 5
> > .
> > .
> > Abort
> > => mii dump 1 0
> > 0. (1940) -- PHY control register --
> > (8000:0000) 0.15 = 0 reset
> > (4000:0000) 0.14 = 0 loopback
> > (2040:0040) 0. 6,13 = b10 speed selection = 1000 Mbps
> > (1000:1000) 0.12 = 1 A/N enable
> > (0800:0800) 0.11 = 1 power-down
> > (0400:0000) 0.10 = 0 isolate
> > (0200:0000) 0. 9 = 0 restart A/N
> > (0100:0100) 0. 8 = 1 duplex = full
> > (0080:0000) 0. 7 = 0 collision test enable
> > (003f:0000) 0. 5- 0 = 0 (reserved)
> >
> > When I manually toggle the power down bit it starts to work again.
> >
> > => mii write 1 0 1140
> > => dhcp
> > FEC Waiting for PHY auto negotiation to complete........ done
> > BOOTP broadcast 1
> > DHCP client bound to address 192.168.0.12 (62 ms)
> >
> > I tried performing the above steps in the PHY driver code with little luck.
> >
> > When I toggle the bit in the code the first dhcp always fails but then it
> > works on subsequent attempts.
> >
> > Any ideas?
> > Has anyone else seen this issue with other PHYs?
>
> Could you try to revert 59370f3fc as suggested here?
> https://www.mail-archive.com/u-boot@lists.denx.de/msg191196.html
So I added the following lines to my board_phy_config function and the problem
seems to be fixed:
.
.
ctl = phy_read(phydev, MDIO_DEVAD_NONE, MII_BMCR);
if (ctl & BMCR_PDOWN) {
ctl &= ~BMCR_PDOWN;
phy_write(phydev, MDIO_DEVAD_NONE, MII_BMCR, ctl);
mdelay(15);
}
.
.
Should this be handled somewhere in the PHY driver core?
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
