Add board_usb_phy_mode weak function on similar lines to ehci-mx6.
However since Vybrid USB does not have a true OTG, make this weak
functon just return 0. The function is supposed to be implemented
by the individual boards using a GPIO for providing the OTG pin
functionality.
Signed-off-by: Sanchayan Maity <maitysancha...@gmail.com>
---
There seems to be a problem here. As per DFU's help note,
the first argument to dfu is the USB controller.
So if dfu 1 nand 2 is run, I would expect the ehci_hcd_init
function's first index argument to recieve 1. However this
does not seem to be the case. Not sure if I am understanding
something wrongly here. Is this expected?
Currently because of this even though I did like dfu 1 nand 2
to bail out, it does not. I tried tracing the code from do_dfu
but I have yet to get from where ehci_hcd_init is getting called
in the call chain.
All seems to be well when using usb start.
---
drivers/usb/host/ehci-vf.c | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/drivers/usb/host/ehci-vf.c b/drivers/usb/host/ehci-vf.c
index 351e0fb..335e303 100644
--- a/drivers/usb/host/ehci-vf.c
+++ b/drivers/usb/host/ehci-vf.c
@@ -121,6 +121,11 @@ static void usb_oc_config(int index)
setbits_le32(ctrl, UCTRL_OVER_CUR_DIS);
}
+int __weak board_usb_phy_mode(int port)
+{
+ return 0;
+}
+
int __weak board_ehci_hcd_init(int port)
{
return 0;
@@ -130,6 +135,7 @@ int ehci_hcd_init(int index, enum usb_init_type init,
struct ehci_hccr **hccr, struct ehci_hcor **hcor)
{
struct usb_ehci *ehci;
+ enum usb_init_type type;
if (index >= ARRAY_SIZE(nc_reg_bases))
return -EINVAL;
@@ -148,6 +154,10 @@ int ehci_hcd_init(int index, enum usb_init_type init,
*hcor = (struct ehci_hcor *)((uint32_t)*hccr +
HC_LENGTH(ehci_readl(&(*hccr)->cr_capbase)));
+ type = board_usb_phy_mode(index);
+ if (type != init)
+ return -ENODEV;
+
if (init == USB_INIT_DEVICE) {
setbits_le32(&ehci->usbmode, CM_DEVICE);
writel((PORT_PTS_UTMI | PORT_PTS_PTW), &ehci->portsc);
--
2.6.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
