Hi Stefano,
On Tue, Oct 20, 2015 at 03:59:18PM +0200, Stefano Babic wrote:
>Hi Peng,
>
>On 20/10/2015 13:39, Peng Fan wrote:
>> Introudce a new function lcdif_power_down.
>>
>> 1. Waits for a VSYNC interrupt to guarantee the reset is done at the
>> VSYNC edge, which somehow makes the LCDIF consume the display FIFO(?)
>> and helps the LCDIF work normally at the kernel stage.
>> 2. Add power down function to stop lcdif.
>>
>> The reason to introduce lcdif_power_down is that we want lcdif to be in
>> initial state when doing uboot reset or before kernel boot to make
>> system stable, otherwise system may hang.
>>
>
>The explanation is independent from the processor type. But checking in
>the next patch, this code runs only for 6UL. Why not for the 6sx ?
We met the issue on i.MX6UL EVK, but did not met issue on i.MX6SX SDB.
So I add the check. After a thought, it should be open to CONFIG_VIDEO_MXS.
To those which use LPDDR2 or LPDDR3, if LCDIF is enabled, lcdif_power_down
is a must, since there is no reset pin as DDR3. No reset pin will make
ddr not stable. Anyway lcdif_power_down do not hurts to those use DDR3.
Will use
#ifdef CONFIG_VIDEO_MXS
lcdif_power_down();
#endif
Regards,
Peng.
>
>
>> Signed-off-by: Peng Fan <peng....@freescale.com>
>> Cc: Stefano Babic <sba...@denx.de>
>> Cc: Anatolij Gustschin <ag...@denx.de>
>> ---
>>
>> V2:
>> none
>>
>> arch/arm/include/asm/imx-common/sys_proto.h | 2 ++
>> drivers/video/mxsfb.c | 17 +++++++++++++++++
>> 2 files changed, 19 insertions(+)
>>
>> diff --git a/arch/arm/include/asm/imx-common/sys_proto.h
>> b/arch/arm/include/asm/imx-common/sys_proto.h
>> index 5673fb4..386c2dc 100644
>> --- a/arch/arm/include/asm/imx-common/sys_proto.h
>> +++ b/arch/arm/include/asm/imx-common/sys_proto.h
>> @@ -47,6 +47,8 @@ int fecmxc_initialize(bd_t *bis);
>> u32 get_ahb_clk(void);
>> u32 get_periph_clk(void);
>>
>> +void lcdif_power_down(void);
>> +
>> int mxs_reset_block(struct mxs_register_32 *reg);
>> int mxs_wait_mask_set(struct mxs_register_32 *reg, u32 mask, u32 timeout);
>> int mxs_wait_mask_clr(struct mxs_register_32 *reg, u32 mask, u32 timeout);
>> diff --git a/drivers/video/mxsfb.c b/drivers/video/mxsfb.c
>> index eed57d5..ddbb118 100644
>> --- a/drivers/video/mxsfb.c
>> +++ b/drivers/video/mxsfb.c
>> @@ -131,6 +131,23 @@ static void mxs_lcd_init(GraphicDevice *panel,
>> writel(LCDIF_CTRL_RUN, ®s->hw_lcdif_ctrl_set);
>> }
>>
>> +void lcdif_power_down(void)
>> +{
>> + struct mxs_lcdif_regs *regs = (struct mxs_lcdif_regs *)MXS_LCDIF_BASE;
>> + int timeout = 1000000;
>> +
>> + writel(panel.frameAdrs, ®s->hw_lcdif_cur_buf_reg);
>> + writel(panel.frameAdrs, ®s->hw_lcdif_next_buf_reg);
>> + writel(LCDIF_CTRL1_VSYNC_EDGE_IRQ, ®s->hw_lcdif_ctrl1_clr);
>> + while (--timeout) {
>> + if (readl(®s->hw_lcdif_ctrl1_reg) &
>> + LCDIF_CTRL1_VSYNC_EDGE_IRQ)
>> + break;
>> + udelay(1);
>> + }
>> + mxs_reset_block((struct mxs_register_32 *)®s->hw_lcdif_ctrl_reg);
>> +}
>> +
>> void *video_hw_init(void)
>> {
>> int bpp = -1;
>>
>
>Best regards,
>Stefano Babic
>
>--
>=====================================================================
>DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
>HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
>Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
>=====================================================================
--
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
