After silencing the prints which were generated when reconfiguring the
clock of the SD/MMC bus, surprisingly, the driver stopped working such
that every attempt to use the SD/MMC bus caused the CPU to get totally
stuck hard. It turns out that the prints generated a short delay, which
was necessary for the CPU to reconfigure the clock without getting stuck.
Thus, this patch adds a short delay after the clock configuration instead.
Signed-off-by: Marek Vasut <ma...@denx.de>
---
drivers/mmc/gen_atmel_mci.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/mmc/gen_atmel_mci.c b/drivers/mmc/gen_atmel_mci.c
index 2815e57..8b05fcd 100644
--- a/drivers/mmc/gen_atmel_mci.c
+++ b/drivers/mmc/gen_atmel_mci.c
@@ -113,6 +113,8 @@ static void mci_set_mode(struct mmc *mmc, u32 hz, u32
blklen)
if (mmc->card_caps & mmc->cfg->host_caps & MMC_MODE_HS)
writel(MMCI_BIT(HSMODE), &mci->cfg);
+ udelay(50);
+
initialized = 1;
}
--
2.1.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
