According to the SDHC specification, stopping the SD Clock is by setting
the SD Clock Enable bit in the Clock Control register at 0, instead of
setting all bits at 0.
Before stopping the SD clock, we need to make sure all SD transactions
to complete, so add checking the CMD and DAT bits in the Presen State
register, before stopping the SD clock.
Signed-off-by: Wenyou Yang <wenyou.y...@atmel.com>
---
Changes in v2:
- Add timeout to wait for the cmd & data inhibit bit
drivers/mmc/sdhci.c | 20 ++++++++++++++++++--
1 file changed, 18 insertions(+), 2 deletions(-)
diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c
index d89e302..02d71b9 100644
--- a/drivers/mmc/sdhci.c
+++ b/drivers/mmc/sdhci.c
@@ -286,9 +286,25 @@ static int sdhci_send_command(struct mmc *mmc, struct
mmc_cmd *cmd,
static int sdhci_set_clock(struct mmc *mmc, unsigned int clock)
{
struct sdhci_host *host = mmc->priv;
- unsigned int div, clk, timeout;
+ unsigned int div, clk, timeout, reg;
- sdhci_writew(host, 0, SDHCI_CLOCK_CONTROL);
+ /* Wait max 20 ms */
+ timeout = 200;
+ while (sdhci_readl(host, SDHCI_PRESENT_STATE) &
+ (SDHCI_CMD_INHIBIT | SDHCI_DATA_INHIBIT)) {
+ if (timeout == 0) {
+ printf("%s: Timeout to wait cmd & data inhibit\n",
+ __func__);
+ return -1;
+ }
+
+ timeout--;
+ udelay(100);
+ }
+
+ reg = sdhci_readw(host, SDHCI_CLOCK_CONTROL);
+ reg &= ~SDHCI_CLOCK_CARD_EN;
+ sdhci_writew(host, reg, SDHCI_CLOCK_CONTROL);
if (clock == 0)
return 0;
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
