It is easier to paste these into the command line if they are a single
common. Use line continuation instead of separate lines.
Signed-off-by: Simon Glass <s...@chromium.org>
---
Changes in v5:
- Add new patch to put README image creation commands on one line
Changes in v4: None
Changes in v3: None
Changes in v2: None
doc/README.rockchip | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)
diff --git a/doc/README.rockchip b/doc/README.rockchip
index feb11ff..87ce9d2 100644
--- a/doc/README.rockchip
+++ b/doc/README.rockchip
@@ -67,7 +67,8 @@ Connect your board's OTG port to your computer.
To create a suitable image and write it to the board:
- ./firefly-rk3288/tools/mkimage -T rkimage -d
./firefly-rk3288/spl/u-boot-spl-dtb.bin out
+ ./firefly-rk3288/tools/mkimage -T rkimage -d \
+ ./firefly-rk3288/spl/u-boot-spl-dtb.bin out && \
cat out | openssl rc4 -K 7c4e0304550509072d2c7b38170d1711 | rkflashtool l
If all goes well you should something like:
@@ -89,8 +90,9 @@ Booting from an SD card
To write an image that boots from an SD card (assumed to be /dev/sdc):
- ./firefly-rk3288/tools/mkimage -T rksd -d
firefly-rk3288/spl/u-boot-spl-dtb.bin out
- sudo dd if=out of=/dev/sdc seek=64
+ ./firefly-rk3288/tools/mkimage -T rksd -d \
+ firefly-rk3288/spl/u-boot-spl-dtb.bin out && \
+ sudo dd if=out of=/dev/sdc seek=64 && \
sudo dd if=firefly-rk3288/u-boot-dtb.img of=/dev/sdc seek=256
This puts the Rockchip header and SPL image first and then places the U-Boot
--
2.5.0.457.gab17608
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
