[U-Boot] [PATCH 02/21] usb: gadget: ether: Perform board initialization from ethernet gadget driver

[Kishon Vijay Abraham I]

Ethernet gadget driver can be used both by both SPL and u-boot. Since
usb_eth_init() is the entry point for ethernet gadget driver, perform
board initialization there. Also perform the cleanup in usb_eth_halt.

Signed-off-by: Kishon Vijay Abraham I <kis...@ti.com>
---
 drivers/usb/gadget/ether.c |    4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/usb/gadget/ether.c b/drivers/usb/gadget/ether.c
index 141ff8b..850ba02 100644
--- a/drivers/usb/gadget/ether.c
+++ b/drivers/usb/gadget/ether.c
@@ -15,6 +15,7 @@
 #include <linux/usb/cdc.h>
 #include <linux/usb/gadget.h>
 #include <net.h>
+#include <usb.h>
 #include <malloc.h>
 #include <linux/ctype.h>
 
@@ -2312,6 +2313,8 @@ static int usb_eth_init(struct eth_device *netdev, bd_t 
*bd)
                goto fail;
        }
 
+       board_usb_init(0, USB_INIT_DEVICE);
+
        /* Configure default mac-addresses for the USB ethernet device */
 #ifdef CONFIG_USBNET_DEV_ADDR
        strlcpy(dev_addr, CONFIG_USBNET_DEV_ADDR, sizeof(dev_addr));
@@ -2492,6 +2495,7 @@ void usb_eth_halt(struct eth_device *netdev)
        }
 
        usb_gadget_unregister_driver(&eth_driver);
+       board_usb_cleanup(0, USB_INIT_DEVICE);
 }
 
 static struct usb_gadget_driver eth_driver = {
-- 
1.7.9.5

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot