Dear Eric Benard,

In message <1247948834-30856-1-git-send-email-e...@eukrea.com> you wrote:
> CPUAT91 is built around Atmel's AT91SAM9260 and has up to 64MB of NOR
> flash, up to 128MB of SDRAM, up to 2GB of NAND and includes a 10/100
> Ethernet PHY in RMII mode.
> 
...
> --- a/Makefile
> +++ b/Makefile
> @@ -2813,6 +2813,19 @@ at91sam9rlek_config    :       unconfig
>       fi;
>       @$(MKCONFIG) -a at91sam9rlek arm arm926ejs at91sam9rlek atmel at91
>  
> +cpu9260_64m_config \
> +cpu9260_config       :       unconfig
> +     @$(MKCONFIG) -a cpu9260 arm arm926ejs cpu9260 eukrea at91
> +     @if [ "$(findstring _64m,$@)" ] ; then \
> +             echo "#define CONFIG_SYS_SDRC_CR_VAL 
> CONFIG_SYS_SDRC_CR_VAL_64MB" \
> +                     >>$(obj)include/config.h ; \
> +             $(XECHO) "... with 64MB SDRAM" ; \
> +     else \
> +             echo "#define CONFIG_SYS_SDRC_CR_VAL 
> CONFIG_SYS_SDRC_CR_VAL_128MB" \
> +                     >>$(obj)include/config.h ; \
> +             $(XECHO) "... with 128MB SDRAM" ; \
> +     fi;

This makes no sense to me. "mkconfig  -a"  (i.  e.  in  append  mode)
should  be  used AFTER manually initializing the config files. Either
omit the "-a", or move the line down.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
Drawing on my fine command of language, I said nothing.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to