Adding actual Tom's address. Cheers, Michal
On 07/28/2015 03:41 PM, Michal Simek wrote: > Hi Tom, > > please pull these changes to your tree. The most of that changes are DT > related which is simple synchronization DTSes with the kernel where > binding was properly reviewed. > > Thanks, > Michal > > The following changes since commit 26473945ad6667183296e7edee2a65edf31bb6f7: > > Merge branch 'master' of http://git.denx.de/u-boot-sunxi (2015-07-25 > 09:04:18 -0400) > > are available in the git repository at: > > git://www.denx.de/git/u-boot-microblaze.git zynq > > for you to fetch changes up to 711e5e26b41457e658155e7c225c9ccfed0182ef: > > cmd_mp: Add support for showing all CPU status by one command > (2015-07-28 11:56:29 +0200) > > ---------------------------------------------------------------- > Michal Simek (29): > zynq: gem: Setting up WRAP bit for one TX bd > zynqmp: mp: Simplify set_r5_start handling > zynqmp: Add support for IP detection via SLCR > ARM: zynq: DT: Use the right names for nodes > ARM: zynq: DT: Add missing nodes to DTSI > ARM: zynq: DT: Add a fixed regulator for CPU voltage > ARM: zynq: DT: Migrate UART to Cadence binding > ARM: zynq: DT: Remove 222 MHz OPP > spi: Fix zynq SPI binding > ARM: zynq: DT: Fix GEM register area size > ARM: zynq: DT: Use the zynq binding with macb > ARM: zynq: DT: Clean up timer device tree nodes > ARM: zynq: DT: Cleanup address-cells and size-cells > ARM: zynq: DT: Add pinctrl node > ARM: zynq: DT: Add reference to bus node > ARM: zynq: DT: Sync zc702/zc706/zed/zybo DT with kernel > ARM: zynq: DT: Update years in copyright > ARM: zynq: DT: Get rid of ps-clk-frequency > ARM: zynq: DT: Add missing interrupt for L2 pl310 > ARM: zynq: DT: Add zc702 pushbuttons to DT as gpio-keys > ARM: zynq: DT: Update zc770 dtses > ARM: zynq: Add support for zc770-xm011 > ARM: zynqmp: Wire up ethernet controllers > ARM: zynqmp: Wire up SATA for the board > zynqmp: Show EL level where U-Boot runs > net: gem: Extend timeout value > zynq: Fix typo in Makefile about custom ps7_init file > spi: zynq_spi: Simplify debug macro > cmd_mp: Add support for showing all CPU status by one command > > Siva Durga Prasad Paladugu (7): > zynqmp: gem: Set data bus width to 64bit for arm64 > zynqmp: gem: Flush the rx buffers while transmitting > zynq: gem: Increase the Rx buffer descriptors to 32 > zynqmp: Kconfig: Move zynqmp Kconfig > zynqmp: Define ep config for ZynqMP > Kconfig: zynqmp: Move CONFIG_SYS_TEXT_BASE to defconfig > zynqmp: Provide option to enable uart dcc support for zynqmp > > Kconfig | 2 +- > arch/arm/Kconfig | 5 ++- > arch/arm/cpu/armv8/Makefile | 2 +- > arch/arm/cpu/armv8/zynqmp/Kconfig | 23 > ++++++++++ > arch/arm/cpu/armv8/zynqmp/Makefile | 1 + > arch/arm/cpu/armv8/zynqmp/mp.c | 7 +-- > arch/arm/cpu/armv8/zynqmp/slcr.c | 63 > +++++++++++++++++++++++++++ > arch/arm/dts/Makefile | 1 + > arch/arm/dts/zynq-7000.dtsi | 174 > +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++------------ > arch/arm/dts/zynq-zc702.dts | 372 > ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++-- > arch/arm/dts/zynq-zc706.dts | 293 > +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++-- > arch/arm/dts/zynq-zc770-xm010.dts | 75 > +++++++++++++++++++++++++++++--- > arch/arm/dts/zynq-zc770-xm011.dts | 65 > ++++++++++++++++++++++++++++ > arch/arm/dts/zynq-zc770-xm012.dts | 51 > ++++++++++++++++++++-- > arch/arm/dts/zynq-zc770-xm013.dts | 62 > ++++++++++++++++++++++++-- > arch/arm/dts/zynq-zed.dts | 46 > ++++++++++++++++++-- > arch/arm/dts/zynq-zybo.dts | 38 > ++++++++++++++-- > arch/arm/include/asm/arch-zynqmp/hardware.h | 16 > +++++++ > arch/arm/include/asm/arch-zynqmp/sys_proto.h | 6 +++ > board/xilinx/zynq/Makefile | 2 +- > board/xilinx/zynqmp/Kconfig | 15 > ------- > board/xilinx/zynqmp/MAINTAINERS | 5 ++- > board/xilinx/zynqmp/zynqmp.c | 37 > ++++++++++++++++ > common/cmd_mp.c | 22 > ++++++++++ > configs/{xilinx_zynqmp_defconfig => xilinx_zynqmp_ep_defconfig} | 5 ++- > configs/zynq_zc770_xm011_defconfig | 13 > ++++++ > doc/device-tree-bindings/spi/spi-zynq.txt | 35 > ++++++++------- > drivers/net/zynq_gem.c | 26 > ++++++++--- > drivers/spi/zynq_spi.c | 4 +- > include/configs/xilinx_zynqmp.h | 48 > +++++++++++++++++---- > include/configs/xilinx_zynqmp_ep.h | 27 > ++++++++++++ > include/configs/zynq_zc770.h | 3 ++ > 32 files changed, 1427 insertions(+), 117 deletions(-) > create mode 100644 arch/arm/cpu/armv8/zynqmp/Kconfig > create mode 100644 arch/arm/cpu/armv8/zynqmp/slcr.c > create mode 100644 arch/arm/dts/zynq-zc770-xm011.dts > delete mode 100644 board/xilinx/zynqmp/Kconfig > rename configs/{xilinx_zynqmp_defconfig => xilinx_zynqmp_ep_defconfig} > (81%) > create mode 100644 configs/zynq_zc770_xm011_defconfig > create mode 100644 include/configs/xilinx_zynqmp_ep.h > -- Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91 w: www.monstr.eu p: +42-0-721842854 Maintainer of Linux kernel - Microblaze cpu - http://www.monstr.eu/fdt/ Maintainer of Linux kernel - Xilinx Zynq ARM architecture Microblaze U-BOOT custodian and responsible for u-boot arm zynq platform
signature.asc
Description: OpenPGP digital signature
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot