On 03/06/2015 11:33, Christian Gmeiner wrote: > On this bus there is a EEPROM containing EDID and ddr3 > calibration information. > > Signed-off-by: Christian Gmeiner <christian.gmei...@gmail.com> > --- > board/bachmann/ot1200/ot1200.c | 15 +++++++++++++++ > 1 file changed, 15 insertions(+) > > diff --git a/board/bachmann/ot1200/ot1200.c b/board/bachmann/ot1200/ot1200.c > index a33d496..2237b7a 100644 > --- a/board/bachmann/ot1200/ot1200.c > +++ b/board/bachmann/ot1200/ot1200.c > @@ -122,6 +122,20 @@ static void setup_iomux_features(void) > > #define PC MUX_PAD_CTRL(I2C_PAD_CTRL) > > +/* I2C2 - EEPROM */ > +static struct i2c_pads_info i2c_pad_info1 = { > + .scl = { > + .i2c_mode = MX6_PAD_EIM_EB2__I2C2_SCL | PC, > + .gpio_mode = MX6_PAD_EIM_EB2__GPIO2_IO30 | PC, > + .gp = IMX_GPIO_NR(2, 30) > + }, > + .sda = { > + .i2c_mode = MX6_PAD_EIM_D16__I2C2_SDA | PC, > + .gpio_mode = MX6_PAD_EIM_D16__GPIO3_IO16 | PC, > + .gp = IMX_GPIO_NR(3, 16) > + } > +}; > + > /* I2C3 - IO expander */ > static struct i2c_pads_info i2c_pad_info2 = { > .scl = { > @@ -138,6 +152,7 @@ static struct i2c_pads_info i2c_pad_info2 = { > > static void setup_iomux_i2c(void) > { > + setup_i2c(1, CONFIG_SYS_I2C_SPEED, 0x7f, &i2c_pad_info1); > setup_i2c(2, CONFIG_SYS_I2C_SPEED, 0x7f, &i2c_pad_info2); > } > > Applied to u-boot-imx, thanks !
Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, Managing Director: Wolfgang Denk HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot