Hi Fabio, On Fri, May 29, 2015 at 4:36 PM, Fabio Estevam <feste...@gmail.com> wrote: > Hi Andrei, > > On Fri, May 29, 2015 at 8:57 AM, Andrei Gherzan <and...@gherzan.ro> wrote: >> Hello Otavio, >> >> Same results with: >> $ sudo dd if=SPL of=/dev/mmcblk0 conv=notrunc seek=2 bs=512 ; sync >> [sudo] password for agherzan: >> $ sudo dd if=u-boot.img of=/dev/mmcblk0 conv=notrunc seek=69 bs=1K ; sync > > I don't have access to hummingboard dual-lite version, so never tested it. > > Just reviewed the code and found some issues. > > Could you please try the following? > > --- a/board/solidrun/mx6cuboxi/mx6cuboxi.c > +++ b/board/solidrun/mx6cuboxi/mx6cuboxi.c > @@ -536,7 +536,7 @@ static const struct mx6_mmdc_calibration > mx6dl_1g_mmcd_calib > .p0_mpdgctrl0 = 0x023C0224, > .p0_mpdgctrl1 = 0x02000220, > .p1_mpdgctrl0 = 0x02200220, > - .p1_mpdgctrl1 = 0x02000220, > + .p1_mpdgctrl1 = 0x02040208, > .p0_mprddlctl = 0x44444846, > .p1_mprddlctl = 0x4042463C, > .p0_mpwrdlctl = 0x32343032, > @@ -627,7 +627,7 @@ static void spl_dram_init(int width) > else if (is_cpu_type(MXC_CPU_MX6Q)) > mx6_dram_cfg(&sysinfo, &mx6q_2g_mmcd_calib, &mem_ddr_4g); > else if (is_cpu_type(MXC_CPU_MX6DL)) > - mx6_dram_cfg(&sysinfo, &mx6q_1g_mmcd_calib, &mem_ddr_2g); > + mx6_dram_cfg(&sysinfo, &mx6dl_1g_mmcd_calib, &mem_ddr_2g); > else if (is_cpu_type(MXC_CPU_MX6SOLO)) > mx6_dram_cfg(&sysinfo, &mx6dl_512m_mmcd_calib, &mem_ddr_2g); > }
This patch fixes the boot issue. Thank you. -- Andrei Gherzan e: and...@gherzan.ro w: www.gherzan.ro _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
