I will try, It will take a while due to I am not working with
latest code. I do have a chip with first 2 parameter blocks
corrupted. So I can test it. I can not send it to Linux -
I am not subscribed to any Linux mailing lists.
As of patch structure:
1) separate READID and PARAM command.
2) READID will read 5 bytes as per ONFI spec.
3) PARAM command will read 768 bytes as per ONFI spec.
I will check is path to send read size are valid
for this command - but it will affect every NAND driver,
It is dangers changing. First approach is save, will
not eliminate other divers problems if they exist.
I will update only fsl_elbc_nand driver.
This is least invasive patch.
Should I get just master for generation of this patch?
Andrei.
On Mon, 2015-05-18 at 16:17 -0500, Scott Wood wrote:
> On Fri, 2015-05-15 at 14:48 -0700, Andrei Yakimov wrote:
> > Hi,
> > I just found, if NAND ONFI parameter page first copy is
> > bad, u-boot will never read extra copes:
> >
> > fsl_elbc_nand.c:
> > 342 out_be32(&lbc->fbcr, 256);
> > 343 ctrl->read_bytes = 256;
> >
> > this code cause "read beyond buffer" error message:
> >
> > nand_base.c:
> > chip->cmdfunc(mtd, NAND_CMD_PARAM, 0, -1);
> > 3243 for (i = 0; i < 3; i++) {
> > 3244 for (j = 0; j < sizeof(*p); j++)
> > 3245 ((uint8_t *)p)[j] = chip->read_byte(mtd);
> > 3246 if (onfi_crc16(ONFI_CRC_BASE, (uint8_t *)p, 254) ==
> > 3247 le16_to_cpu(p->crc)) {
> > 3248 break;
> > 3249 }
> > 3250 }
> >
> > Unfortunately I do not working with latest u-boot now,
> > so can not provide a patch, read size should be increased to
> > at least 768 ( 3 copy mandatory for ONFI spec). Linux kernel should be
> > updated too.
>
> Could you send a patch (both here and Linux)? Especially since you have
> a test case. :-)
>
> Though a better fix than just increasing the byte count would be to add
> a read_id() callback so that the NAND subsystem can actually tell the
> driver how much data it's expecting, rather than forcing it to go
> through cmdfunc that makes high-level drivers (poorly) emulate
> low-level hardware.
>
> > I am also not expert for other NAND controllers drivers.
>
> At least IFC will have the same issue.
>
> -Scott
>
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
