On Tue, Apr 28, 2015 at 04:17:53PM -0700, Ash Charles wrote:
> Overo COMs have NAND flash that requires 4-bit ECC or better except for
> the first sector which can use 1-bit ECC. The boot ROM expects to load
> a payload from NAND written using 1-bit hardware-based ECC. In short,
> write SPL to NAND something like this (4 times for redundancy):
> #> nandecc hw
> #> nand write ${loadaddr} 0x0 ${filesize}
> #> nand write ${loadaddr} 0x20000 ${filesize}
> #> nand write ${loadaddr} 0x40000 ${filesize}
> #> nand write ${loadaddr} 0x60000 ${filesize}
>
> Then, switch back to software-based BCH8 for everything else:
> #> nandecc sw bch8
>
> After [1], enlarge the max size of the SPL so the BCH code can fit.
>
> [1] https://www.mail-archive.com/u-boot@lists.denx.de/msg163912.html
>
> Signed-off-by: Ash Charles <ashchar...@gmail.com>Applied to u-boot/master, thanks! -- Tom
signature.asc
Description: Digital signature
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
