Hi Fabio,
On 04/05/2015 16:22, Fabio Estevam wrote:
> Configure PAD_ENET_RXD0/RXD1 pads as pull down because these pads are directly
> connected to the Atheros 8035/8030 although they should be functional
> only in the RMII mode - 8030.
>
> Signed-off-by: Rabeeh Khoury <rab...@solid-run.com>
> Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
> ---
> Changes since v1:
> - None
> board/solidrun/mx6cuboxi/mx6cuboxi.c | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/board/solidrun/mx6cuboxi/mx6cuboxi.c
> b/board/solidrun/mx6cuboxi/mx6cuboxi.c
> index ff018e1..8fb6004 100644
> --- a/board/solidrun/mx6cuboxi/mx6cuboxi.c
> +++ b/board/solidrun/mx6cuboxi/mx6cuboxi.c
> @@ -134,6 +134,8 @@ static iomux_v3_cfg_t const enet_pads[] = {
> IOMUX_PADS(PAD_RGMII_RD2__RGMII_RD2 | MUX_PAD_CTRL(ENET_PAD_CTRL)),
> IOMUX_PADS(PAD_RGMII_RD3__RGMII_RD3 | MUX_PAD_CTRL(ENET_PAD_CTRL)),
> IOMUX_PADS(PAD_RGMII_RX_CTL__RGMII_RX_CTL |
> MUX_PAD_CTRL(ENET_PAD_CTRL_PD)),
> + IOMUX_PADS(PAD_ENET_RXD0__GPIO1_IO27 | MUX_PAD_CTRL(ENET_PAD_CTRL_PD)),
> + IOMUX_PADS(PAD_ENET_RXD1__GPIO1_IO26 | MUX_PAD_CTRL(ENET_PAD_CTRL_PD)),
> };
>
> static void setup_iomux_enet(void)
>
Reviewed-by: Stefano Babic <sba...@denx.de>
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
