HI Hans,
On 24 April 2015 at 07:48, Hans de Goede <hdego...@redhat.com> wrote:
> The device-model gpio functions may return another value then -1 as error,
> make the sunxi mmc code properly handle this.
FYI I tend to call it 'drive model' rather than 'device model'. It
might be good to change your commit messages it to avoid confusion.
Reviewed-by: Simon Glass <s...@chromium.org>
>
> Signed-off-by: Hans de Goede <hdego...@redhat.com>
> ---
> drivers/mmc/sunxi_mmc.c | 7 ++++---
> 1 file changed, 4 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/mmc/sunxi_mmc.c b/drivers/mmc/sunxi_mmc.c
> index fcc278d..a664236 100644
> --- a/drivers/mmc/sunxi_mmc.c
> +++ b/drivers/mmc/sunxi_mmc.c
> @@ -9,6 +9,7 @@
> */
>
> #include <common.h>
> +#include <errno.h>
> #include <malloc.h>
> #include <mmc.h>
> #include <asm/io.h>
> @@ -37,7 +38,7 @@ static int sunxi_mmc_getcd_gpio(int sdc_no)
> case 2: return sunxi_name_to_gpio(CONFIG_MMC2_CD_PIN);
> case 3: return sunxi_name_to_gpio(CONFIG_MMC3_CD_PIN);
> }
> - return -1;
> + return -EINVAL;
> }
>
> static int mmc_resource_init(int sdc_no)
> @@ -72,7 +73,7 @@ static int mmc_resource_init(int sdc_no)
> mmchost->mmc_no = sdc_no;
>
> cd_pin = sunxi_mmc_getcd_gpio(sdc_no);
> - if (cd_pin != -1) {
> + if (cd_pin >= 0) {
> ret = gpio_request(cd_pin, "mmc_cd");
> if (!ret)
> ret = gpio_direction_input(cd_pin);
> @@ -424,7 +425,7 @@ static int sunxi_mmc_getcd(struct mmc *mmc)
> int cd_pin;
>
> cd_pin = sunxi_mmc_getcd_gpio(mmchost->mmc_no);
> - if (cd_pin == -1)
> + if (cd_pin < 0)
> return 1;
>
> return !gpio_get_value(cd_pin);
> --
> 2.3.5
>
Regards,
Simon
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
