Adjust the Ethernet initialisation code to support driver model.
It is no-longer necessary to call designware_initialize(). The device will
be probed when it is used. The PHY type and GMAC base will come from the
device tree.
Signed-off-by: Simon Glass <s...@chromium.org>
---
Changes in v2:
- Remove unwanted printf()
board/sunxi/gmac.c | 10 +++++++---
1 file changed, 7 insertions(+), 3 deletions(-)
diff --git a/board/sunxi/gmac.c b/board/sunxi/gmac.c
index 8849132..1540633 100644
--- a/board/sunxi/gmac.c
+++ b/board/sunxi/gmac.c
@@ -80,11 +80,15 @@ int sunxi_gmac_initialize(bd_t *bis)
sunxi_gpio_set_cfgpin(pin, SUN6I_GPA0_GMAC);
#endif
-#ifdef CONFIG_RGMII
+#ifdef CONFIG_DM_ETH
+ return 0;
+#else
+# ifdef CONFIG_RGMII
return designware_initialize(SUNXI_GMAC_BASE, PHY_INTERFACE_MODE_RGMII);
-#elif defined CONFIG_GMII
+# elif defined CONFIG_GMII
return designware_initialize(SUNXI_GMAC_BASE, PHY_INTERFACE_MODE_GMII);
-#else
+# else
return designware_initialize(SUNXI_GMAC_BASE, PHY_INTERFACE_MODE_MII);
+# endif
#endif
}
--
2.2.0.rc0.207.ga3a616c
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
