Hi Hans,

On 03/27/2015 03:08 AM, Hans de Goede wrote:
Hi,

First of all I'm not sure this is a regression, but I'm afraid
I do not have time to dig deeper so I thought I should report
it anyways and then others can try to reproduce it.

I'm seeing the following happen when using a usb stick
with a musb-new otg controller in host mode on an allwinner
tablet:

sunxi# usb reset
resetting USB...
USB0:   scanning bus 0 for devices... 1 USB Device(s) found
        scanning usb for storage devices... error in inquiry
0 Storage Device(s) found

The interesting thing is that, the first "usb start" works
fine, this only happens on the second usb start (triggered
through a usb reset).

This may be specific to using musb on sunxi, or to the
flashdrive I have but I thought I should report this
anyways. Esp. since usb otherwise works fine after a
usb reset, other devices (usb keyboards) continue to
work, and the descriptors of the usb drive do get read
correctly:


sunxi# usb info
1: Mass Storage,  USB Revision 2.0
  - USB Flash Disk 4C0E960F
  - Class: (from Interface) Mass Storage
  - PacketSize: 64  Configurations: 1
  - Vendor: 0x058f  Product 0x6387 Version 1.3
    Configuration: 1
    - Interfaces: 1 Bus Powered 100mA
      Interface: 0
      - Alternate Setting 0, Endpoints: 2
      - Class Mass Storage, Transp. SCSI, Bulk only
      - Endpoint 1 Out Bulk MaxPacket 512
      - Endpoint 2 In Bulk MaxPacket 512


Perhaps someone can test the reproducer on another board
with usb:

1) plug in a usb drive
2) do "usb start"
3) should print that 1 storage device is found
4) do "usb reset"
5) should still print that 1 storage device is found,
but for me gives the error I mentioned above.

I tested it OK with EHCI on Atmel sama5d4ek board. The following information for your reference.
--->8---
U-Boot SPL 2015.04-rc4-00067-gf643d92 (Mar 27 2015 - 14:31:49)


U-Boot 2015.04-rc4-00067-gf643d92 (Mar 27 2015 - 14:31:49)

CPU: SAMA5D44
Crystal frequency:       12 MHz
CPU clock        :      528 MHz
Master clock     :      176 MHz
DRAM:  512 MiB
NAND:  512 MiB
MMC:   mci: 0
In:    serial
Out:   serial
Err:   serial
Net:   gmac0, usb_ether
Error: usb_ether address not set.

Hit any key to stop autoboot:  0
U-Boot> usb start
starting USB...
USB0:   USB EHCI 1.00
scanning bus 0 for devices... 2 USB Device(s) found
       scanning usb for storage devices... 1 Storage Device(s) found
U-Boot> usb reset
resetting USB...
USB0:   USB EHCI 1.00
scanning bus 0 for devices... 2 USB Device(s) found
       scanning usb for storage devices... 1 Storage Device(s) found
U-Boot>
---8<---

Regards,

Hans

Best Regards,
Bo Shen
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to