On Do, 2015-03-26 at 10:39 +0100, Jörg Krause wrote: > Reading the GPIOs for getting the boot mode does not show the correct result > for USB boot mode in case the recovery switch, eg. BM2 for switching from NAND > to USB boot mode, is hold down while plugging in USB and released before > U-Boot > is loaded by mxsldr. > > This state is stored in the HW_OCOTP_ROM0 register. HW_OCOTP_ROM0[27:24] maps > to > BM3-BM0, HW_OCOTP_ROM0[28] maps to voltage selector. > > For using mxs_wait_mask_clr() add imx-common/misc.o to the SPL build. > > Signed-off-by: Jörg Krause <joerg.krause@embedded.rocks> > Cc: Stefano Babic <sba...@denx.de> > ---
This patch is superseded by: ARM: mxs: Get boot mode from OCRAM http://patchwork.ozlabs.org/patch/455231/ _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
