Hi, > I have enabled Netconsole option on my customized powerpc 7410 > based processor board. I have set ncip as my host machine which is connected > through serial port (Now act as debug port but i need the ethernet to be > debug port). i have set stdout and stdin as nc as mentioned on the > doc/Readme.Netconsole. On the host system i have ran the script which is > provided in the the Readme document. > After giving the commands on Target, the host machine is not > giving the output correctly both input as well as output. When i type some > character on the host side , i am getting some junk as output that too for > some time only. After the target stops to respond.
It is very hard to diagnose such a problem from the distance. Did you check whether the network driver for your board works at all reliably, i.e. can you tftp files successfully? If this is the case I guess you will need to debug the problems as netconsole does not have any current known (generic) problems. Cheers Detlev -- Q: What does FAQ stand for? A: We are Frequently Asked this Question, and we have no idea. -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: d...@denx.de _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
