This configures the Juno board to enable ethernet using the
SMSC9118 ethernet controller found in the board. Tested by
TFTP-booting a kernel over ethernet.
Signed-off-by: Linus Walleij <linus.wall...@linaro.org>
---
board/armltd/vexpress64/vexpress64.c | 3 +++
include/configs/vexpress_aemv8a.h | 12 ++++++++++--
2 files changed, 13 insertions(+), 2 deletions(-)
diff --git a/board/armltd/vexpress64/vexpress64.c
b/board/armltd/vexpress64/vexpress64.c
index 7ab000cca77b..de6286435d97 100644
--- a/board/armltd/vexpress64/vexpress64.c
+++ b/board/armltd/vexpress64/vexpress64.c
@@ -137,5 +137,8 @@ int board_eth_init(bd_t *bis)
#ifdef CONFIG_SMC91111
rc = smc91111_initialize(0, CONFIG_SMC91111_BASE);
#endif
+#ifdef CONFIG_SMC911X
+ rc = smc911x_initialize(0, CONFIG_SMC911X_BASE);
+#endif
return rc;
}
diff --git a/include/configs/vexpress_aemv8a.h
b/include/configs/vexpress_aemv8a.h
index e276fff7e442..5ffc84dc5ecd 100644
--- a/include/configs/vexpress_aemv8a.h
+++ b/include/configs/vexpress_aemv8a.h
@@ -138,9 +138,17 @@
/* Size of malloc() pool */
#define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + (8 << 20))
-/* SMSC91C111 Ethernet Configuration */
+/* Ethernet Configuration */
+#ifdef CONFIG_TARGET_VEXPRESS64_JUNO
+/* The real hardware Versatile express uses SMSC9118 */
+#define CONFIG_SMC911X 1
+#define CONFIG_SMC911X_32_BIT 1
+#define CONFIG_SMC911X_BASE (0x018000000)
+#else
+/* The Vexpress64 simulators use SMSC91C111 */
#define CONFIG_SMC91111 1
#define CONFIG_SMC91111_BASE (0x01A000000)
+#endif
/* PL011 Serial Configuration */
#define CONFIG_PL011_SERIAL
@@ -229,7 +237,7 @@
"fdt_addr_r=0x83000000\0"
\
"fdt_high=0xa0000000\0"
-#define CONFIG_BOOTARGS "console=ttyAMA0 root=/dev/ram0"
+#define CONFIG_BOOTARGS "console=ttyAMA0,115200n8
root=/dev/ram0"
#define CONFIG_BOOTCOMMAND "bootm $kernel_addr_r " \
"$initrd_addr_r:$initrd_size
$fdt_addr_r"
#define CONFIG_BOOTDELAY -1
--
1.9.3
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
