> -----Original Message----- > From: Dieter Kiermaier [mailto:dk-arm-li...@gmx.de] > Sent: Tuesday, June 23, 2009 2:18 PM > To: Jean-Christophe PLAGNIOL-VILLARD > Cc: Prafulla Wadaskar; u-boot@lists.denx.de; Scott Wood; > Ashish Karkare; Prabhanjan Sarnaik; Ronen Shitrit > Subject: Re: [U-Boot] [PATCH v2 1/3][repost] nand: Add > Marvell Kirkwood NAND driver > > Am Dienstag 23 Juni 2009 10:35:31 schrieb Jean-Christophe > PLAGNIOL-VILLARD: > > > > > I2C lowest priority (as per need) > > > > > > Can I do something to push I2C priority? Any way this driver will be arround TWSI controller interface by h/w Again if you are using different pins then may not be helpful for you
> > > > If the I/O is shared with gpio you can use bitbanging with few hours > > I think this would be the best to start - due to the fact > that I need bitbanging for FPGA flashing, too. This is a good Idea, start your development with accessing GPIO registers directly Regards.. Prafulla . . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot