These functions are going away, so use the new uclass support instead.
Signed-off-by: Simon Glass <s...@chromium.org>
---
drivers/mtd/nand/tegra_nand.c | 9 ++++-----
1 file changed, 4 insertions(+), 5 deletions(-)
diff --git a/drivers/mtd/nand/tegra_nand.c b/drivers/mtd/nand/tegra_nand.c
index 163cf29..b660f3b 100644
--- a/drivers/mtd/nand/tegra_nand.c
+++ b/drivers/mtd/nand/tegra_nand.c
@@ -79,7 +79,7 @@ enum {
struct fdt_nand {
struct nand_ctlr *reg;
int enabled; /* 1 to enable, 0 to disable */
- struct fdt_gpio_state wp_gpio; /* write-protect GPIO */
+ struct gpio_desc wp_gpio; /* write-protect GPIO */
s32 width; /* bit width, normally 8 */
u32 timing[FDT_NAND_TIMING_COUNT];
};
@@ -945,8 +945,8 @@ static int fdt_decode_nand(const void *blob, int node,
struct fdt_nand *config)
config->reg = (struct nand_ctlr *)fdtdec_get_addr(blob, node, "reg");
config->enabled = fdtdec_get_is_enabled(blob, node);
config->width = fdtdec_get_int(blob, node, "nvidia,nand-width", 8);
- err = fdtdec_decode_gpio(blob, node, "nvidia,wp-gpios",
- &config->wp_gpio);
+ err = gpio_request_by_name_nodev(blob, node, "nvidia,wp-gpios", 0,
+ &config->wp_gpio, GPIOD_IS_OUT);
if (err)
return err;
err = fdtdec_get_int_array(blob, node, "nvidia,timing",
@@ -1009,8 +1009,7 @@ int tegra_nand_init(struct nand_chip *nand, int devnum)
/* Adjust timing for NAND device */
setup_timing(config->timing, info->reg);
- fdtdec_setup_gpio(&config->wp_gpio);
- gpio_direction_output(config->wp_gpio.gpio, 1);
+ dm_gpio_set_value(&config->wp_gpio, 1);
our_mtd = &nand_info[devnum];
our_mtd->priv = nand;
--
2.2.0.rc0.207.ga3a616c
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
