Hi Nikita,

On 29/10/2014 18:28, Nikita Kiryanov wrote:
> The bmode command forces the SoC to use a specific boot device
> by writing its boot mode into SRC_GPR9, and notifying the SoC of
> the change using SRC_GPR10[28] bit: if the bit is on, bootROM
> uses the value in SRC_GPR9 instead of SRC_SMBR1 to determine
> the boot device.
> 
> SPL on the other hand is oblivious to this distinction, so once
> the bootROM loads SPL from the device configured in SRC_GPR10,
> SPL will attempt to load U-Boot from the device configured in
> SRC_SMBR1, which is not updated by the bootROM to the value in
> SRC_GPR9.
> 
> The result is that the selected boot device is not used across all
> the boot stages.
> 
> Update spl_boot_device() to look at gpr9 when necessary.
> 
> Signed-off-by: Nikita Kiryanov <nik...@compulab.co.il>
> Cc: Stefano Babic <sba...@denx.de>
> Cc: Troy Kisky <troy.ki...@boundarydevices.com>
> Cc: Tim Harvey <thar...@gateworks.com>
> Cc: Eric Nelson <eric.nel...@boundarydevices.com>
> Cc: Fabio Estevam <fabio.este...@freescale.com>
> Cc: Heiko Schocher <h...@denx.de>
> ---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to