Dear Ian, In message <1414677435.2064.34.ca...@hellion.org.uk> you wrote: > It seems there is some inconsistency wrt number base between commands > which set $filesize in the env and the commands which might consume > them.
That would be bugs, then. > > sun7i# load scsi 0 $fdt_addr_r dtbs/$fdtfile > 21639 bytes read in 191 ms (110.4 KiB/s) > sun7i# printenv filesize > filesize=5487 > > So filesize is in hex, but without an 0x prefix. But: This is normal. U-Boot uses hex input base by default. All commands should take hex input; the only inglorious exception is the "sleep" command which takes decimal; numbers as arguments. > sun7i# fdt addr $fdt_addr_r 0x10000 > sun7i# fdt set /chosen foo <$filesize> > sun7i# fdt print /chosen foo > foo = <0x0000156f> > > IOW the parameter to fdt set has been interpreted as a decimal. That's a bug. > So I'm not sure if the bug is that setenv_hex doesn't include the 0x, or No 0x prefix should be needed anywhere. > that fdt set interprets things as decimal by default instead of hex. Or > maybe there is no bug at all? The bug is in fdt set, then. Thanks for pointing out! Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Prediction is very difficult, especially of the future. - Niels Bohr _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot