On Thu 2014-10-30 10:30:25, Marek Vasut wrote:
> Add example config file entry for the Altera SPI controller. This SPI
> controller can also, under special conditions, be used to operate the
> EPCS/EPCQ SPI NOR.
>
> Signed-off-by: Marek Vasut <ma...@denx.de>
> Cc: Chin Liang See <cl...@altera.com>
> Cc: Dinh Nguyen <dingu...@opensource.altera.com>
> Cc: Vince Bridgers <vbrid...@altera.com>
Acked-by: Pavel Machek <pa...@denx.de>
> --- a/include/configs/socfpga_common.h
> +++ b/include/configs/socfpga_common.h
> @@ -79,6 +79,25 @@
> #define CONFIG_SYS_PL310_BASE SOCFPGA_MPUL2_ADDRESS
>
> /*
> + * EPCS/EPCQx1 Serial Flash Controller
> + */
> +#ifdef CONFIG_ALTERA_SPI
> +#define CONFIG_CMD_SPI
> +#define CONFIG_CMD_SF
> +#define CONFIG_SF_DEFAULT_SPEED 30000000
> +#define CONFIG_SPI_FLASH
> +#define CONFIG_SPI_FLASH_STMICRO
> +#define CONFIG_SPI_FLASH_BAR
> +/*
> + * The base address is configurable in QSys, each board must specify the
> + * base address based on it's particular FPGA configuration. Please note
> + * that the address here is incremented by 0x400 from the Base address
Are the double spaces around 0x400 intentional?
Pavel
--
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures)
http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
