Dear Heiko, On 01.10.14 07:54, Heiko Schocher wrote: > use the configure value for computing the ba_off value > not the value from the cr register. This leaded in a > wrong ram configuration on the upcoming corvus spl board > support. > > Signed-off-by: Heiko Schocher <h...@denx.de> > Cc: Andreas Bießmann <andreas.de...@googlemail.com> > Cc: Bo Shen <voice.s...@atmel.com>
Reviewed-by: Andreas Bießmann <andreas.de...@googlemail.com> > --- > arch/arm/cpu/at91-common/mpddrc.c | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > diff --git a/arch/arm/cpu/at91-common/mpddrc.c > b/arch/arm/cpu/at91-common/mpddrc.c > index 8136396..76668d2 100644 > --- a/arch/arm/cpu/at91-common/mpddrc.c > +++ b/arch/arm/cpu/at91-common/mpddrc.c > @@ -26,7 +26,8 @@ int ddr2_init(const unsigned int ram_address, > /* Compute bank offset according to NC in configuration register */ > ba_off = (mpddr_value->cr & ATMEL_MPDDRC_CR_NC_MASK) + 9; > if (!(mpddr_value->cr & ATMEL_MPDDRC_CR_DECOD_INTERLEAVED)) > - ba_off += ((mpddr->cr & ATMEL_MPDDRC_CR_NR_MASK) >> 2) + 11; > + ba_off += ((mpddr_value->cr & ATMEL_MPDDRC_CR_NR_MASK) >> 2) > + + 11; ugly 80 char rule ... > > ba_off += (mpddr_value->md & ATMEL_MPDDRC_MD_DBW_MASK) ? 1 : 2; > > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
