Dear Stefan Roese,
In message <200906040856.51774...@denx.de> you wrote:
>
> > I used ubiformat from Linux using /dev/ubi0 which is attached to
> > /dev/mtd4 which again points to the same area in the flash than
> > 'ubilayer' does in U-Boot. So I should be able to access that same
> > volume from the bootloader, right? Or do I miss some important point?
>
> I have to admit that I never used it this way. Using "ubi part" on an erased
> partition works fine. I suggest you give it a try.
But that seems a perfectly valid, and actually pretty resonable test
szenario. I think you should include this in your tests.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
Keep your eyes wide open before marriage, half shut afterwards.
-- Benjamin Franklin
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
