OK. Please mark old patches superseded. York
On 10/15/2014 02:04 AM, Kumar Ashish-B37399 wrote: > Hi York, > > Please see the attached mail. > Since SPI is not supported by fdt_fixup_mtdparts() same is removed in V2 > > Regards > Ashish > > -----Original Message----- > From: Sun York-R58495 > Sent: Wednesday, October 15, 2014 1:51 AM > To: Kumar Ashish-B37399 > Cc: Wood Scott-B07421; u-Boot@lists.denx.de > Subject: Re: [PATCH] powerpc/BSC9132QDS: Enable creation of dynamic partition > for NAND and NOR > > On 10/14/2014 01:19 PM, Kumar Ashish-B37399 wrote: >> Hi York, >> >> Yes, I should superseed/reject the below patches >> >> http://patchwork.ozlabs.org/patch/391991/ > > I think your v2 patch reduced the size of SPI. Please check before you mark > them superseded. > > York > >> http://patchwork.ozlabs.org/patch/391990/ >> >> Regards >> Ashish >> >> -----Original Message----- >> From: Sun York-R58495 >> Sent: Wednesday, October 15, 2014 1:44 AM >> To: Kumar Ashish-B37399; u-Boot@lists.denx.de >> Cc: Wood Scott-B07421 >> Subject: Re: [PATCH] powerpc/BSC9132QDS: Enable creation of dynamic >> partition for NAND and NOR >> >> On 10/06/2014 05:54 AM, Ashish Kumar wrote: >>> * fdt_fixup_mtdparts is called from ft_board_setup >>> * run "mtdparts default" to create NAND, NOR partition on uboot >>> * Use mtdparts to create partitions dynamically rather >>> than using static partitions in device tree >>> >>> Signed-off-by: Ashish Kumar <ashish.ku...@freescale.com> >>> --- >>> board/freescale/bsc9132qds/bsc9132qds.c | 12 ++++++++++++ >>> include/configs/BSC9132QDS.h | 21 +++++++++++++++++++++ >>> 2 files changed, 33 insertions(+), 0 deletions(-) >>> >>> diff --git a/board/freescale/bsc9132qds/bsc9132qds.c >>> b/board/freescale/bsc9132qds/bsc9132qds.c >>> index 10580bc..c88838b 100644 >>> --- a/board/freescale/bsc9132qds/bsc9132qds.c >>> +++ b/board/freescale/bsc9132qds/bsc9132qds.c >>> @@ -21,6 +21,9 @@ >>> #include <hwconfig.h> >>> #include <i2c.h> >>> #include <fsl_ddr_sdram.h> >>> +#include <jffs2/load_kernel.h> >>> +#include <mtd_node.h> >>> +#include <flash.h> >>> >>> #ifdef CONFIG_PCI >>> #include <pci.h> >>> @@ -354,6 +357,12 @@ void fdt_del_node_compat(void *blob, const char >>> *compatible) } >>> >>> #if defined(CONFIG_OF_BOARD_SETUP) >>> +#ifdef CONFIG_FDT_FIXUP_PARTITIONS >>> +struct node_info nodes[] = { >>> + { "cfi-flash", MTD_DEV_TYPE_NOR, }, >>> + { "fsl,ifc-nand", MTD_DEV_TYPE_NAND, }, >>> +}; >>> +#endif >>> void ft_board_setup(void *blob, bd_t *bd) { >>> phys_addr_t base; >>> @@ -369,6 +378,9 @@ void ft_board_setup(void *blob, bd_t *bd) >>> #endif >>> >>> fdt_fixup_memory(blob, (u64)base, (u64)size); >>> +#ifdef CONFIG_FDT_FIXUP_PARTITIONS >>> + fdt_fixup_mtdparts(blob, nodes, ARRAY_SIZE(nodes)); #endif >>> >>> ccsr_gur_t *gur = (void *)(CONFIG_SYS_MPC85xx_GUTS_ADDR); >>> u32 porbmsr = in_be32(&gur->porbmsr); diff --git >>> a/include/configs/BSC9132QDS.h b/include/configs/BSC9132QDS.h index >>> aeded6d..da78a19 100644 >>> --- a/include/configs/BSC9132QDS.h >>> +++ b/include/configs/BSC9132QDS.h >>> @@ -630,6 +630,27 @@ combinations. this should be removed later >>> #endif >>> >>> /* >>> + * Dynamic MTD Partition support with mtdparts */ #ifndef >>> +CONFIG_SYS_NO_FLASH #define CONFIG_MTD_DEVICE #define >>> +CONFIG_MTD_PARTITIONS #define CONFIG_CMD_MTDPARTS #define >>> +CONFIG_FLASH_CFI_MTD #define MTDIDS_DEFAULT >>> +"nor0=88000000.nor,nand0=ff800000.flash," >>> +#define MTDPARTS_DEFAULT "mtdparts=88000000.nor:256k(dtb),7m(kernel)," \ >>> + "55m(fs),1m(uboot);ff800000.flash:1m(uboot)," \ >>> + "8m(kernel),512k(dtb),-(fs)" >>> +#endif >> >> >> Isn't this patch conflict with your earlier patch? >> http://patchwork.ozlabs.org/patch/391991/ >> >> York >> > _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
