[U-Boot] [PATCH 1/2] mmc: fsl_esdhc: Update esdhc driver for iMX6SX

[Ye . Li]

The reset value of "uSDHCx_INT_STATUS_EN" register is changed to 0
on iMX6SX. So the fsl_esdhc driver must update to set the register,
otherwise no state can be detected.

Signed-off-by: Ye.Li <b37...@freescale.com>
---
 drivers/mmc/fsl_esdhc.c |   13 +++++++++++++
 1 files changed, 13 insertions(+), 0 deletions(-)

diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c
index 97d0389..9c8a8d4 100644
--- a/drivers/mmc/fsl_esdhc.c
+++ b/drivers/mmc/fsl_esdhc.c
@@ -23,6 +23,11 @@
 
 DECLARE_GLOBAL_DATA_PTR;
 
+#define SDHCI_IRQ_EN_BITS              (IRQSTATEN_CC | IRQSTATEN_TC | \
+                               IRQSTATEN_CINT | \
+                               IRQSTATEN_CTOE | IRQSTATEN_CCE | IRQSTATEN_CEBE 
| \
+                               IRQSTATEN_CIE | IRQSTATEN_DTOE | IRQSTATEN_DCE 
| IRQSTATEN_DEBE)
+
 struct fsl_esdhc {
        uint    dsaddr;         /* SDMA system address register */
        uint    blkattr;        /* Block attributes register */
@@ -492,8 +497,15 @@ static int esdhc_init(struct mmc *mmc)
        /* Set the initial clock speed */
        mmc_set_clock(mmc, 400000);
 
+#ifdef CONFIG_SYS_FSL_ESDHC_USE_PIO
+       /* Enable the BRR and BWR bits in IRQSTAT */
+       esdhc_clrbits32(&regs->irqstaten, IRQSTATEN_DINT);
+       esdhc_setbits32(&regs->irqstaten, IRQSTATEN_BRR | IRQSTATEN_BWR);
+#else
        /* Disable the BRR and BWR bits in IRQSTAT */
        esdhc_clrbits32(&regs->irqstaten, IRQSTATEN_BRR | IRQSTATEN_BWR);
+       esdhc_setbits32(&regs->irqstaten, IRQSTATEN_DINT);
+#endif
 
        /* Put the PROCTL reg back to the default */
        esdhc_write32(&regs->proctl, PROCTL_INIT);
@@ -558,6 +570,7 @@ int fsl_esdhc_initialize(bd_t *bis, struct fsl_esdhc_cfg 
*cfg)
        esdhc_setbits32(&regs->sysctl, SYSCTL_PEREN | SYSCTL_HCKEN
                                | SYSCTL_IPGEN | SYSCTL_CKEN);
 
+       writel(SDHCI_IRQ_EN_BITS, &regs->irqstaten);
        memset(&cfg->cfg, 0, sizeof(cfg->cfg));
 
        voltage_caps = 0;
-- 
1.7.4.1

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot