Hi Fabio,

On 10/11/2014 04:39 AM, Fabio Estevam wrote:
Hi Marek,

On Fri, Oct 10, 2014 at 10:14 PM, Marek Vasut <ma...@denx.de> wrote:

+int board_early_init_f(void)
+{
+#if defined(CONFIG_VIDEO_IPUV3)
+       setup_display();
+#endif
+
+       /* Bring Ethernet PHY out of reset. */
+       gpio_set_value(IMX_GPIO_NR(3, 23), 1);

No delay needed here prior to setting it to 1?

We had some discussions about the PHY reset sequence and timing, but still not a common opinion, so I suggested to leave this fix for a consequent patch.

Regards,
Nikolay
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to