Please, ignore this patch. Pushed by mistake. > >Signed-off-by: Akshay Saraswat >--- >arch/arm/cpu/armv7/exynos/Kconfig | 5 +- >arch/arm/dts/Makefile | 3 +- >arch/arm/dts/exynos5800-peach-pi.dts | 157 +++++++++++++++++++++++++++++++++++ >board/samsung/smdk5420/Kconfig | 16 ++++ >board/samsung/smdk5420/MAINTAINERS | 2 + >configs/peach-pi_defconfig | 4 + >include/configs/exynos5420.h | 2 +- >include/configs/peach-pi.h | 35 ++++++++ >8 files changed, 221 insertions(+), 3 deletions(-) >create mode 100644 arch/arm/dts/exynos5800-peach-pi.dts >create mode 100644 configs/peach-pi_defconfig >create mode 100644 include/configs/peach-pi.h > >diff --git a/arch/arm/cpu/armv7/exynos/Kconfig >b/arch/arm/cpu/armv7/exynos/Kconfig >index b6a558b..76c0faf 100644 >--- a/arch/arm/cpu/armv7/exynos/Kconfig >+++ b/arch/arm/cpu/armv7/exynos/Kconfig >@@ -33,9 +33,12 @@ config TARGET_SNOW >config TARGET_SMDK5420 >bool "SMDK5420 board" > >-config TARGET_PEACH_PIT >+config TARGET_PEACH_PI >bool "Peach Pi board" > >+config TARGET_PEACH_PIT >+ bool "Peach Pit board" >+ >endchoice > >config SYS_CPU >diff --git a/arch/arm/dts/Makefile b/arch/arm/dts/Makefile >index 1ccd827..36e68d7 100644 >--- a/arch/arm/dts/Makefile >+++ b/arch/arm/dts/Makefile >@@ -8,7 +8,8 @@ dtb-$(CONFIG_EXYNOS5) += exynos5250-arndale.dtb \ >exynos5250-snow.dtb \ >exynos5250-smdk5250.dtb \ >exynos5420-smdk5420.dtb \ >- exynos5420-peach-pit.dtb >+ exynos5420-peach-pit.dtb \ >+ exynos5800-peach-pi.dtb >dtb-$(CONFIG_MX6) += imx6q-sabreauto.dtb >dtb-$(CONFIG_TEGRA) += tegra20-harmony.dtb \ >tegra20-medcom-wide.dtb \ >diff --git a/arch/arm/dts/exynos5800-peach-pi.dts >b/arch/arm/dts/exynos5800-peach-pi.dts >new file mode 100644 >index 0000000..1c6aa8f >--- /dev/null >+++ b/arch/arm/dts/exynos5800-peach-pi.dts >@@ -0,0 +1,157 @@ >+/* >+ * SAMSUNG/GOOGLE Peach-Pit board device tree source >+ * >+ * Copyright (c) 2013 Samsung Electronics Co., Ltd. >+ * http://www.samsung.com >+ * >+ * SPDX-License-Identifier: GPL-2.0+ >+ */ >+ >+/dts-v1/; >+/include/ "exynos54xx.dtsi" >+ >+/ { >+ model = "Samsung/Google Peach Pi board based on Exynos5800"; >+ >+ compatible = "google,pit-rev#", "google,pit", >+ "google,peach", "samsung,exynos5800", "samsung,exynos5"; >+ >+ config { >+ google,bad-wake-gpios = <&gpio 0x56 0>; /* gpx0-6 */ >+ hwid = "PIT TEST A-A 7848"; >+ lazy-init = <1>; >+ }; >+ >+ aliases { >+ serial0 = "/serial@12C30000"; >+ console = "/serial@12C30000"; >+ pmic = "/i2c@12ca0000"; >+ }; >+ >+ dmc { >+ mem-manuf = "samsung"; >+ mem-type = "ddr3"; >+ clock-frequency = <800000000>; >+ arm-frequency = <1700000000>; >+ }; >+ >+ tmu@10060000 { >+ samsung,min-temp = <25>; >+ samsung,max-temp = <125>; >+ samsung,start-warning = <95>; >+ samsung,start-tripping = <105>; >+ samsung,hw-tripping = <110>; >+ samsung,efuse-min-value = <40>; >+ samsung,efuse-value = <55>; >+ samsung,efuse-max-value = <100>; >+ samsung,slope = <274761730>; >+ samsung,dc-value = <25>; >+ }; >+ >+ /* MAX77802 is on i2c bus 4 */ >+ i2c@12ca0000 { >+ clock-frequency = <400000>; >+ power-regulator@9 { >+ compatible = "maxim,max77802-pmic"; >+ reg = <0x9>; >+ }; >+ }; >+ >+ i2c@12cd0000 { /* i2c7 */ >+ clock-frequency = <100000>; >+ soundcodec@20 { >+ reg = <0x20>; >+ compatible = "maxim,max98090-codec"; >+ }; >+ >+ edp-lvds-bridge@48 { >+ compatible = "parade,ps8625"; >+ reg = <0x48>; >+ }; >+ }; >+ >+ sound@3830000 { >+ samsung,codec-type = "max98090"; >+ }; >+ >+ i2c@12e10000 { /* i2c9 */ >+ clock-frequency = <400000>; >+ tpm@20 { >+ compatible = "infineon,slb9645-tpm"; >+ reg = <0x20>; >+ }; >+ }; >+ >+ spi@12d30000 { /* spi1 */ >+ spi-max-frequency = <50000000>; >+ firmware_storage_spi: flash@0 { >+ reg = <0>; >+ >+ /* >+ * A region for the kernel to store a panic event >+ * which the firmware will add to the log. >+ */ >+ elog-panic-event-offset = <0x01e00000 0x100000>; >+ >+ elog-shrink-size = <0x400>; >+ elog-full-threshold = <0xc00>; >+ }; >+ }; >+ >+ spi@12d40000 { /* spi2 */ >+ spi-max-frequency = <4000000>; >+ spi-deactivate-delay = <200>; >+ cros-ec@0 { >+ reg = <0>; >+ compatible = "google,cros-ec"; >+ spi-half-duplex; >+ spi-max-timeout-ms = <1100>; >+ spi-frame-header = <0xec>; >+ ec-interrupt = <&gpio 93 1>; /* GPX1_5 */ >+ >+ /* >+ * This describes the flash memory within the EC. Note >+ * that the STM32L flash erases to 0, not 0xff. >+ */ >+ #address-cells = <1>; >+ #size-cells = <1>; >+ flash@8000000 { >+ reg = <0x08000000 0x20000>; >+ erase-value = <0>; >+ }; >+ }; >+ }; >+ >+ xhci@12000000 { >+ samsung,vbus-gpio = <&gpio 0x40 0>; /* H00 */ >+ }; >+ >+ xhci@12400000 { >+ samsung,vbus-gpio = <&gpio 0x41 0>; /* H01 */ >+ }; >+ >+ fimd@14400000 { >+ samsung,vl-freq = <60>; >+ samsung,vl-col = <1920>; >+ samsung,vl-row = <1080>; >+ samsung,vl-width = <1920>; >+ samsung,vl-height = <1080>; >+ >+ samsung,vl-clkp; >+ samsung,vl-dp; >+ samsung,vl-bpix = <4>; >+ >+ samsung,vl-hspw = <80>; >+ samsung,vl-hbpd = <172>; >+ samsung,vl-hfpd = <60>; >+ samsung,vl-vspw = <10>; >+ samsung,vl-vbpd = <25>; >+ samsung,vl-vfpd = <10>; >+ samsung,vl-cmd-allow-len = <0xf>; >+ >+ samsung,winid = <3>; >+ samsung,interface-mode = <1>; >+ samsung,dp-enabled = <1>; >+ samsung,dual-lcd-enabled = <0>; >+ }; >+}; >diff --git a/board/samsung/smdk5420/Kconfig b/board/samsung/smdk5420/Kconfig >index fb9bedd..b88722f 100644 >--- a/board/samsung/smdk5420/Kconfig >+++ b/board/samsung/smdk5420/Kconfig >@@ -1,3 +1,19 @@ >+if TARGET_PEACH_PI >+ >+config SYS_BOARD >+ string >+ default "smdk5420" >+ >+config SYS_VENDOR >+ string >+ default "samsung" >+ >+config SYS_CONFIG_NAME >+ string >+ default "peach-pi" >+ >+endif >+ >if TARGET_PEACH_PIT > >config SYS_BOARD >diff --git a/board/samsung/smdk5420/MAINTAINERS >b/board/samsung/smdk5420/MAINTAINERS >index c8241a8..25813d5 100644 >--- a/board/samsung/smdk5420/MAINTAINERS >+++ b/board/samsung/smdk5420/MAINTAINERS >@@ -2,7 +2,9 @@ SMDK5420 BOARD >M: Akshay Saraswat >S: Maintained >F: board/samsung/smdk5420/ >+F: include/configs/peach-pi.h >F: include/configs/peach-pit.h >+F: configs/peach-pi_defconfig >F: configs/peach-pit_defconfig > >SMDK5420 BOARD >diff --git a/configs/peach-pi_defconfig b/configs/peach-pi_defconfig >new file mode 100644 >index 0000000..8cb3946 >--- /dev/null >+++ b/configs/peach-pi_defconfig >@@ -0,0 +1,4 @@ >+CONFIG_SPL=y >++S:CONFIG_ARM=y >++S:CONFIG_ARCH_EXYNOS=y >++S:CONFIG_TARGET_PEACH_PI=y >diff --git a/include/configs/exynos5420.h b/include/configs/exynos5420.h >index d2a9556..9780050 100644 >--- a/include/configs/exynos5420.h >+++ b/include/configs/exynos5420.h >@@ -27,7 +27,7 @@ > >#define CONFIG_SPL_MAX_FOOTPRINT (30 * 1024) > >-#define CONFIG_DEVICE_TREE_LIST "exynos5420-peach-pit exynos5420-smdk5420" >+#define CONFIG_DEVICE_TREE_LIST "exynos5800-peach-pi exynos5420-peach-pit >exynos5420-smdk5420" > >#define CONFIG_MAX_I2C_NUM 11 > >diff --git a/include/configs/peach-pi.h b/include/configs/peach-pi.h >new file mode 100644 >index 0000000..b66b781 >--- /dev/null >+++ b/include/configs/peach-pi.h >@@ -0,0 +1,35 @@ >+/* >+ * Copyright (C) 2014 Samsung Electronics >+ * >+ * Configuration settings for the SAMSUNG/GOOGLE PEACH-PI board. >+ * >+ * SPDX-License-Identifier: GPL-2.0+ >+ */ >+ >+#ifndef __CONFIG_PEACH_PI_H >+#define __CONFIG_PEACH_PI_H >+ >+#include >+ >+#include >+ >+#undef CONFIG_DEFAULT_DEVICE_TREE >+#define CONFIG_DEFAULT_DEVICE_TREE exynos5800-peach-pi >+ >+/* select serial console configuration */ >+#define CONFIG_SERIAL3 /* use SERIAL 3 */ >+ >+#define CONFIG_SYS_PROMPT "Peach-pi # " >+#define CONFIG_IDENT_STRING " for Peach-pi" >+ >+#define CONFIG_VIDEO_PARADE >+ >+/* Display */ >+#define CONFIG_LCD >+#ifdef CONFIG_LCD >+#define CONFIG_EXYNOS_FB >+#define CONFIG_EXYNOS_DP >+#define LCD_BPP LCD_COLOR16 >+#endif >+ >+#endif /* __CONFIG_PEACH_PI_H */ >-- >1.9.1 > >_______________________________________________ >U-Boot mailing list >U-Boot@lists.denx.de >http://lists.denx.de/mailman/listinfo/u-boot
Regards, Akshay Saraswat _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
