Hi Eric, On 02/10/2014 21:16, Eric Nelson wrote: > This collection of patches comprises a set of updates that have > been lingering in our Github repository. > > We're pushing them to main-line in preparation for the addition > of a couple of boards that have also been lingering for a while. > > Patches 1-9 are tweaks to the mx6qsabrelite/nitrogen6x initialization > code. > > Patches 10-18 add support for additional displays supported by > the board(s) and tweak the HDMI detection. > > Patches 19-32 enable and configure various features through > changes to include/configs/nitrogen6x.h. >
Patches are orthogonal and can be applied separetely. I have not seen any comments and I have not comments for most of them. I will start to apply the ones (most of them) are straightforward. Please wait until I end up with first pass - your next version will be much shorter ! > Diego Rondini (1): > nitrogen6x: config: allow boot to USB stick > > Eric Nelson (24): > nitrogen6x: implement board_cfb_skip() to disable text output > nitrogen6x: configure SD2 pads for SDIO on USDHC2 > nitrogen6x: power-down miscellanous peripherals > nitrogen6x: staticize board file > nitrogen6x: Allow U-Boot to be silent on UART2 > nitrogen6x: prevent warnings about board_ehci* callbacks > nitrogen6x: display: add qvga panel > nitrogen6x: display: add support for LG-9.7 LVDS display > nitrogen6x: display: add LDB-WXGA-S for SPWG 1280x800 displays > nitrogen6x: display: add support for fusion 7 display > nitrogen6x: display: add svga display (800x600) > nitrogen6x: display: add Ampire 1024x600 panel > nitrogen6x: display: add wvga-lvds panel > nitrogen6x: display use I2C detect for HDMI > nitrogen6x: config: add USB Mass Storage (ums) support > nitrogen6x: config: add initrd_high > nitrogen6x: config: expose SATA, then MMC over USB > nitrogen6x: config: enable USB keyboard support > nitrogen6x: config: add CONFIG_CMD_MEMTEST > nitrogen6x: config: enable "i2c edid" > nitrogen6x: config: disable logo > nitrogen6x: config: configure usb_ether Mainly I have problems with fixed addresses - my comments to the related patch. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
