Note we also drop the SPL check for initializing the 2nd mmc slot, the SPL
check is not necessary with Kconfig, because only options explicitly marked
as also being for the SPL get set during SPL builds.
Signed-off-by: Hans de Goede <hdego...@redhat.com>
---
board/sunxi/Kconfig | 8 ++++++++
board/sunxi/board.c | 2 +-
2 files changed, 9 insertions(+), 1 deletion(-)
diff --git a/board/sunxi/Kconfig b/board/sunxi/Kconfig
index 72d6dfa..c9b459a 100644
--- a/board/sunxi/Kconfig
+++ b/board/sunxi/Kconfig
@@ -32,6 +32,14 @@ config USB_KEYBOARD
Say Y here to add support for using a USB keyboard (typically used
in combination with a graphical console on HDMI).
+config MMC_SUNXI_SLOT_EXTRA
+ int "mmc extra slot number"
+ default -1
+ ---help---
+ sunxi builds always enable mmc0, some boards also have a sdcard slot
+ or emmc on mmc2 or mmc3. Setting this to 2 or 3 will enable support
+ for this.
+
config MMC0_CD_PIN
int "Card detect pin for mmc0"
default -1
diff --git a/board/sunxi/board.c b/board/sunxi/board.c
index e819b12..4d602ca 100644
--- a/board/sunxi/board.c
+++ b/board/sunxi/board.c
@@ -110,7 +110,7 @@ int board_mmc_init(bd_t *bis)
{
mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT);
sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT);
-#if !defined (CONFIG_SPL_BUILD) && defined (CONFIG_MMC_SUNXI_SLOT_EXTRA)
+#if CONFIG_MMC_SUNXI_SLOT_EXTRA != -1
mmc_pinmux_setup(CONFIG_MMC_SUNXI_SLOT_EXTRA);
sunxi_mmc_init(CONFIG_MMC_SUNXI_SLOT_EXTRA);
#endif
--
2.1.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
