Hi Nitin, On Tue, Sep 16, 2014 at 3:33 PM, Nitin Garg <nitin.g...@freescale.com> wrote: > When CONFIG_SECURE_BOOT is enabled, the signed images > like kernel and dtb can be authenticated using iMX6 CAAM. > The added command hab_auth_img can be used for HAB > authentication of images. The command takes the image > DDR location, IVT (Image Vector Table) offset inside > image as parameters. Detailed info about signing images > can be found in Freescale AppNote AN4581. > > Signed-off-by: Nitin Garg <nitin.g...@freescale.com>
I have just tested the 'hab_status' command and it hangs my mx6sxsabresd board: U-Boot 2014.10-rc2-16959-g6eb2f0d-dirty (Sep 30 2014 - 10:28:19) CPU: Freescale i.MX6SX rev1.0 at 792 MHz Reset cause: POR Board: MX6SX SABRE SDB I2C: ready DRAM: 1 GiB MMC: FSL_SDHC: 0 In: serial Out: serial Err: serial PMIC: PFUZE100 ID=0x10 Net: FEC [PRIME] Hit any key to stop autoboot: 0 => hab_status Secure boot disabled (hangs the system) Could you please take a look at this issue? _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
