Hello Lukasz,
Am 09.09.2014 15:43, schrieb Lukasz Majewski:
Hi Heiko,
This patchserie adds the new config option CONFIG_DFU_FULLSPEED.
Is there any special reason to support Full Speed (12 Mbit/sec - USB
1.1) and not rely solely on the High Speed (USB 2.0) as we do now?
If this is enabled DFU uses fullspeed only. This is used on the
siemens boards.
Is there any DFU problem with the mentioned Siemens board, that we must
use USB 1.1?
I'd also appreciate more verbose rationale for this patch series - why
this change is needed? What is the expected improvement?
They have a "USB HW protection circuit" and therefore they only allowed
to use fullspeed ...
@Lukas Stockman: Maybe you could answer this better than me?
bye,
Heiko
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
