On Thu, 5 Jun 2014 19:00:14 +0100 Ian Campbell <i...@hellion.org.uk> wrote:
> This is a sun7i (A20) based followup to the sun4i (A10) > Cubieboard. It has GMAC using MII mode. > > Signed-off-by: Ian Campbell <i...@hellion.org.uk> > Acked-by: Hans de Goede <hdego...@redhat.com> This board is using exactly the same PCB as the Cubieboard1. And only the SoC is different (Allwinner A20 instead of the pin-compatible Allwinner A10). Before piling up more board configurations, we might want to consider supporting both Cubieboard1 and Cubieboard2 with a single u-boot binary (and perhaps keep Cubieboard1 and Cubieboard2 as aliases in boards.cfg). The Allwinner SoCs have support for runtime identification of the SoC type (sun4i/sun5i/sun7i) via the VER_REG (Version Register) located at the address 0x01C00024 as explained in the Allwinner A20 user manual. This requires replacing all the CONFIG_SUN4I/CONFIG_SUN5I/CONFIG_SUN7I ifdefs in the u-boot code with a runtime SoC type checks, but there are not too many places affected (mostly just the DRAM code). Here is a quick and dirty example (not a patch submission yet), which allows to boot the Cubieboard2 hardware using the existing Cubieboard1 config: https://github.com/ssvb/u-boot-sunxi-dram/commit/3153905e0221 If the u-boot code is further extended to define a variable with the relevant dtb file name in the u-boot environment (depending on the runtime detected SoC type and selecting from "sun4i-a10-cubieboard.dtb" and "sun7i-a20-cubieboard2.dtb"), then we can have the same SD card with the whole pre-installed Linux system usable on both Cubieboard1 and Cubieboard2 hardware by just swapping the card. Also the Cubieboards are not alone. Sharing the same PCB happens for the LIME boards from Olimex too: https://www.olimex.com/Products/OLinuXino/A10/A10-OLinuXino-LIME https://www.olimex.com/Products/OLinuXino/A20/A20-OLinuXino-LIME > Active arm armv7 sunxi - sunxi > Cubieboard > sun4i:CUBIEBOARD,SPL,AXP209_POWER,SUNXI_EMAC > Hans de Goede > <hdego...@redhat.com> > +Active arm armv7 sunxi - sunxi > Cubieboard2 sun7i:CUBIEBOARD2,SPL,SUNXI_GMAC > > Ian Campbell <i...@hellion.org.uk>:Hans de Goede > <hdego...@redhat.com> > +Active arm armv7 sunxi - sunxi > Cubieboard2_FEL > sun7i:CUBIEBOARD2,SPL_FEL,SUNXI_GMAC > Ian Campbell > <i...@hellion.org.uk>:Hans de Goede <hdego...@redhat.com> The newly added Cubieboard2 from your patch appears to be missing the important AXP209_POWER option. So the patch is not good enough to be pushed anywhere in its current form. -- Best regards, Siarhei Siamashka _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot